Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Amerock concealed hinge hangs 1/2 inch overlay doors on face-frame cabinets with integrated soft-close, sold as a pair.
A 1/2 inch overlay door covers the cabinet side by about half an inch rather than spanning most of the panel face. That is the partial overlay setup used on double-door cabinets where two doors meet on a single center partition, each overlapping the stile by the same amount. This hinge carries the half crank geometry that places the door correctly at that position. The 35mm cup bores into the back of the door, and the hinge arm screws to a separate base plate mounted on the cabinet. The plate is sold separately and should be matched to the same brand and series as this hinge. Reach for this pair on face-frame kitchen cabinets, bath vanities, and built-in casework where partial overlay is part of the design.
The hinge is plated steel in a nickel finish. On partial overlay work, where two doors sit side by side on one partition, soft-close earns its keep in a practical way: it keeps both doors from rattling or slamming against each other at the end of each swing. The integrated damper handles that last arc quietly, protecting the door edges and the finish on the face frame over years of regular use.
This hinge suits cabinet shops fitting face-frame boxes with partial overlay doors, contractors finishing traditional or transitional kitchens, and remodelers matching an existing partial overlay layout. It is a screw-on hinge, so no pre-drilled 5mm system holes are needed in the cabinet. For standard doors in the 16 to 22mm thickness range, this hinge handles the install cleanly. Doors outside that range need a thickness-matched hinge. For full overlay or inset doors on the same job, a different arm geometry is the right call.
No. The hinge arm connects to a base plate that mounts to the cabinet, and that plate is sold separately. Use a plate matched to Amerock's series for this hinge.
When two doors share a center partition or stile, each door should cover only half of it. A full overlay hinge on both doors would push the door edges past center and cause them to collide. The half crank on this hinge sets the door back to the partial position so the two doors meet cleanly.
This product ships as a pair, giving you two hinges. General guidance puts two hinges on doors up to about 40 inches tall, three on taller doors, and more on heavy doors. Check the manufacturer load table for your specific door size and weight to confirm the exact count.
No. Soft-close slows and cushions the door over the last few degrees of travel so it does not slam, but it does not pull the door shut from an open position. Give the door a push to start the close, and the damper handles the quiet landing.
Specify this pair when a face-frame cabinet calls for partial overlay doors that meet neatly on a shared partition and settle closed without a sound.