Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Belwith Keeler Vale Collection pull is a contemporary arch-profile bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers and finished in Champagne Bronze.
The 5-1/16 inch (128 mm) center-to-center is the standard spacing for mid-to-wide drawer fronts, base cabinet drawers, and tall pantry doors. It is wide enough to give a confident grip on a deep drawer and balanced enough to sit well centered on a 15-to-18 inch front. If you are replacing existing hardware drilled to 128 mm, this pull drops directly onto those holes with no new drilling. For new installs, 128 mm is a standard template spacing on most commercial jigs, which keeps layout straightforward across a long run of base cabinets.
The pull is cast in zinc and finished in Champagne Bronze, a warm gold-toned surface with a brushed, low-sheen character. Champagne Bronze reads closer to a subdued antique gold than a bright polish, which is what keeps it at home in a contemporary kitchen rather than a traditional one. It works against white, greige, and natural wood fronts without pulling the room toward a retro look, and it coordinates with warm-toned fixtures in the same space. The arch profile in this finish catches light along the curve rather than reflecting it flat, which adds visual depth without introducing contrast.
This pull suits a contemporary kitchen, bath, or built-in where the hardware runs warm and the drawer fronts are wide. Designers specifying a full kitchen often pair this size on base drawers with a smaller Vale pull or a Vale knob on upper doors, keeping the series consistent and the finish matched. For a cabinet shop building to a designer spec, the 128 mm spacing is easy to template and the Vale collection's range of sizes means one finish can carry the whole project. It is also a practical replacement choice for an existing kitchen already drilled to this spacing that needs a finish update.
The center-to-center spacing is 5-1/16 inches (128 mm). Overall length is larger than that figure; refer to the spec block on this page for the end-to-end measurement.
Champagne Bronze is a low-sheen, warm gold-toned finish. It is not a high-gloss polish, so it reads softer and more subdued than a polished brass or polished gold surface would.
Yes. The Contemporary Vale collection includes pulls in multiple center-to-center sizes and companion knobs in the same Champagne Bronze finish, so you can run a consistent look across doors and drawers.
The 128 mm center-to-center is commonly used on base drawers and wider fronts. Sizing hardware to roughly a third of the front's width is a common design practice, though it is a preference rather than a requirement.
When the project calls for a warm, contemporary pull on a wider drawer front and the holes are already set at 128 mm, the Vale Collection in Champagne Bronze gives you the fit and the finish in one piece.