Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Belwith Keeler Sinclaire pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 6-5/16 inch (160 mm) centers.
The 6-5/16 inch center-to-center puts this pull in the range that suits a mid-to-wide drawer front, a full-height base door, or a tall upper cabinet door. At this spacing the pull has enough span to feel proportional on a front wider than about 15 inches, without reaching so far that it crowds the edges. Cabinet shops building a full kitchen run will typically land here on the wider base drawers and on any stacked drawer bank where the fronts are deep enough to carry a longer pull. Designers working a one-third proportion on a 20-inch drawer often arrive at this center-to-center as the right step up from a 5-1/16 inch pull.
The pull is cast in zinc and finished in Polished Nickel. A polished surface on nickel reads as a cool, bright silver with more clarity than a brushed finish and a warmer undertone than polished chrome. It picks up ambient light along the bar and holds a clean edge at the posts. In a kitchen that already runs nickel fixtures, faucets, or appliances, this pull joins that metal language rather than introducing a new one. Against white, gray, or navy painted fronts it lands as a crisp accent; against natural wood it reads more formal.
This pull suits a contemporary or transitional kitchen, bath, or built-in project where the hardware program is polished nickel and the drawer fronts are on the wider side. Cabinet shops running the Sinclaire collection across a full kitchen will find this center-to-center covers the mid-range drawers and doors, with the 5-1/16 inch pull handling the narrower drawers and the wider spacing options stepping up to appliance-scale fronts. Homeowners replacing hardware on an existing cabinet run drilled to 160 mm centers will find this a straightforward match to their existing hole pattern.
Yes. The center-to-center on this pull is 6-5/16 inches, which is 160 mm. Measure between the centers of your existing holes to confirm the match before ordering.
They are similar in brightness but not the same. Polished Nickel has a slightly warmer, softer tone compared to the cooler, sharper reflectivity of polished chrome. The two are visually close but will read differently side by side.
The Sinclaire series includes knobs and pulls at other center-to-center spacings in the same design language and Polished Nickel finish, so you can mix knobs on doors and pulls on drawers within one coordinated program.
There is no manufacturer requirement, but at 160 mm centers this pull is commonly used on fronts in the 15 to 24 inch range. Sizing to roughly one third of the front width is a common design practice, not a specification.
When the drawer bank steps up in width and the hole pattern lands at 160 mm, this Sinclaire pull covers the span in a finish that coordinates with the rest of the collection.