Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Du Verre Series 3 pull is a contemporary aluminum bar pull for cabinet doors and drawer fronts, mounting on one of the most common hole patterns in residential cabinetry.
This pull is sized for the hole pattern that shows up most often in kitchen and bath cabinetry: a pair of holes drilled 3-3/4 inches apart. That spacing fits upper door panels, mid-width base drawers, and the standard four-drawer stack in a base cabinet. When a project calls for replacing hardware across an existing kitchen without re-drilling, this spacing drops onto most factory-drilled doors without touching them. For new builds, it is the pattern that keeps the hardware program flexible because so many pulls are made to this dimension.
The pull is die-cast in aluminum, which produces a tight, repeatable cross-section across the bar and the posts. The 1/2 inch squared bar keeps the profile flat and linear rather than rounded, so it sits in the same geometric family as a slab or shaker door rather than introducing a curve the front does not have. Satin Nickel is a brushed, low-reflectance surface that holds its appearance under kitchen lighting and does not amplify marks the way a polished silver finish does. It coordinates naturally with stainless appliances and brushed nickel plumbing fixtures without requiring an exact match.
This pull is a practical choice for a designer or cabinet shop specifying hardware across a full kitchen or bath where the hole pattern is already locked in at 3-3/4 inches. The slim aluminum bar and Satin Nickel finish suit a contemporary or transitional room where the hardware should be present but not dominant. It is also a clean answer for a remodel where the goal is a consistent silver-tone hardware program: the muted sheen of Satin Nickel works with chrome, brushed nickel, and stainless without fighting any of them. The Series 3 collection supports a matched set of pulls and companion pieces in the same finish, so mixing knobs on doors and pulls on drawers is straightforward within the line.
Yes. It mounts on 3-3/4 inch centers. Measure between the centers of your existing holes to confirm before ordering.
Aluminum, die-cast. That is the base material, not the finish. Satin Nickel is the surface treatment applied over it.
1-3/8 inches (35 mm) from the face of the front to the back of the grip.
Generally yes. Satin Nickel is a silver-tone, low-sheen finish that reads close to brushed stainless in most lighting conditions. Finishes from different manufacturers are not guaranteed to match exactly, but the tone family is consistent.
The Series 3 collection includes companion pieces in the same design language and finish, so you can coordinate knobs on doors with pulls on drawers within the same program.
Choose this pull when the hole pattern is already set at 3-3/4 inches and the hardware program calls for a slim aluminum bar in a low-sheen silver tone.
Sold In: 1 Each