Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Du Verre Series 3 pull is a contemporary aluminum bar pull designed for cabinet doors and drawer fronts that call for hardware at a larger scale, mounting on 7-1/2 inch (190 mm) centers.
At 190 mm, this pull is sized for situations where a 96 mm or 128 mm pull would read as undersized. Wide base drawers, deep pot-and-pan drawers, pantry doors, and tall upper cabinet doors all benefit from hardware at this scale. The proportion logic is simple: a narrow pull centered on a wide front looks like an afterthought, while a pull that spans roughly a third of the front reads as intentional hardware rather than a grip someone added last. The 7-1/2 inch center-to-center also lines up with a common spacing in higher-end cabinet programs, which makes it a practical replacement dimension for existing installations drilled to that pattern.
The Series 3 pull is built from aluminum and die-cast aluminum, which is the material behind this profile's ability to hold a precise, flat bar section across the full grip span. Aluminum takes a matte anodized or coated finish well, and the Black Matte here has a consistent, low-sheen surface that does not pick up highlights under kitchen task lighting. That low reflectivity keeps the hardware from competing with the cabinetry. On lighter fronts the pull reads as a graphic element; on dark fronts it integrates and nearly disappears. Either way, it avoids the glare of a polished finish without the warm tone of an oil-rubbed one.
This pull is a natural fit for contemporary kitchens, bath vanities, and built-ins where the hardware program is black and the fronts are large enough to warrant a longer pull. It works well in cabinet shops specifying hardware for wide drawer configurations, designers running a uniform black line across a full kitchen elevation, and contractors replacing hardware on existing 7-1/2 inch hole patterns. Because it belongs to the Du Verre Series 3 collection, companion pieces in the same series carry the same profile geometry and finish, which matters when mixing pull lengths across a bank or coordinating door and drawer hardware on a single elevation.
The 7-1/2 inch (190 mm) measurement is the distance between the centers of the two mounting holes, which is what you match to your existing hole pattern or drill layout. The 9-3/4 inch figure is the total end-to-end length of the pull, including the posts and overhang beyond the holes.
Yes. A 7-1/2 inch center-to-center pull is commonly used on taller and wider doors where a shorter pull would look undersized relative to the front.
A matte finish is more forgiving of fingerprints than a polished surface. Smudges are less visible on a low-sheen black than on a bright finish.
Yes. The Series 3 collection is available in multiple center-to-center sizes, so you can run the same profile at different lengths across a cabinet layout.
When the cabinetry is wide, the hardware should be too. This Du Verre Series 3 pull in Black Matte brings the right proportion and a consistent matte finish to drawer and door fronts that a shorter pull cannot anchor.
Sold In: 1 Each