Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Du Verre Wave pull is a decorative cabinet pull for doors and drawer fronts, mounting on 3-3/4 inch centers, one of the most widely drilled hole patterns in residential cabinetry.
A 3-3/4 inch center-to-center pull is the workhorse spacing of cabinet hardware. It suits mid-width drawers, upper cabinet doors, and base doors without feeling undersized or oversized on the front. Because so many cabinets ship pre-drilled at this spacing, this pull is also the right choice when the goal is a hardware refresh with no drilling: confirm the existing hole centers match 3-3/4 inches and it drops straight in. The Wave profile adds enough visual movement to read as intentional hardware rather than a commodity fitting, which makes it a practical upgrade over a plain bar pull at the same spacing.
The pull is cast in aluminum die-cast with a Satin Nickel finish. Aluminum is lighter than zinc and carries a fine, consistent grain that takes a brushed finish evenly across the profile. Satin Nickel sits in the silver tone family: it has enough warmth to avoid the coldness of polished chrome and enough restraint to stay out of the way of the cabinetry. On a flat-front or shaker door it reads as a clean, mid-sheen silver line. On a painted white or gray cabinet it holds contrast without demanding attention the way a polished or high-contrast finish would.
This pull is a strong fit for designers and cabinet shops working on kitchens, bathrooms, or built-ins where the hardware program calls for an artistic or sculptural profile without a finish that reads as loud or trendy. Homeowners replacing existing hardware drilled to the 3-3/4 inch standard will find this a no-modification swap. Contractors sourcing for a full kitchen install where a satin silver tone coordinates with the faucet, light fixtures, or appliance trim can specify this pull across the drawer and door program and add companion Wave collection pieces for a consistent series look throughout the space.
If your existing holes are drilled at 3-3/4 inch centers, this pull mounts directly with no new holes. Measure between the centers of your current holes to confirm before ordering.
The pull projects 1-1/8 inches from the face of the door or drawer front to the back of the grip.
Yes. Aluminum is a lower-density metal than zinc, so a pull of the same dimensions will feel lighter in hand. For cabinet hardware the practical difference is minimal, but it can matter when installing a full run of hardware across a large drawer bank.
The Wave series from Du Verre includes additional pulls at other center-to-center spacings, allowing a consistent design language across doors and drawers of different widths.
Choose this pull when the cabinetry is already drilled at 3-3/4 inches and the hardware program calls for something with more character than a plain bar, finished in a satin silver tone that coordinates across a room without competing with it.
Sold In: 1 Each