
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
The Amerock #6 x 5/8 inch flat head installation screw in Satin Nickel is designed to mount decorative cabinet hardware cleanly and flush, with a finish that blends into the hardware rather than standing apart from it.
At 5/8 inch, this screw has enough length to seat firmly through the mounting hole of a hinge, hinge plate, catch, or surface-mount fitting and into the door or drawer face behind it, without punching through thinner stock. That makes it a practical choice when hardware mounts directly to 3/4-inch cabinet doors or drawer fronts and thread depth matters more than holding a thick stack of material. It also works well for attaching light surface hardware such as corner braces or small catches to panels where a longer screw would be overkill.
Satin Nickel is one of the most common finishes in residential cabinetry, and a screw head in a contrasting finish draws attention to the fastener instead of the hardware. This screw carries the same Satin Nickel finish on its steel body, so the head blends in when it is visible at the edge of a hinge leaf or through an open mounting slot. Amerock supplies this screw as part of its hardware line, which means the finish is matched to their hardware rather than approximated.
Cabinet installers who work with Satin Nickel Amerock hardware keep a supply of these on hand so they are not sourcing mismatched screws at the last minute. Designers who specify Amerock pulls, knobs, and hinges can call out the matching installation screw alongside the hardware to give contractors a complete fastener spec. Homeowners doing a hardware swap on existing cabinetry will find that this screw slots into a straightforward install without needing to size up or modify anything.
This screw is sold separately and is intended as a replacement or supplemental supply for Amerock hardware installations where matching-finish screws are needed.
At 5/8 inch, the screw seats through the hinge plate and into the door face without over-penetrating standard 3/4-inch stock. It is suited for surface-mount hinge hardware on door faces rather than for deep structural connections.
A #2 Phillips bit fits the drive recess. That is the most common bit size for cabinet installation work.
This is a steel screw with a Satin Nickel decorative finish. It is intended for interior cabinet hardware installation, not exterior or moisture-exposed applications.
Choosing a finish-matched installation screw is a small detail that shows in the finished work. This Amerock Satin Nickel flat head screw at 16 mm gives installers, designers, and homeowners a clean, coordinated fastener for standard cabinet hardware mounting.