Schaub Sabre Edge Pull defines a low-profile grip by mounting at the cabinet edge and presenting a simple pull point where your hand naturally lands. The 3 inch center-to-center dimension spaces the mounting holes consistently, which helps line up multiple pulls across doors and drawers. The 4-1/4 inch overall length extends slightly beyond the mounting span, giving fingers a solid purchase while still keeping a tight visual line on modern work. The unlacquered brass material presents raw brass to the environment, so its surface can age and change appearance over time in line with the surrounding millwork. The part designation as an edge pull signals a style that stays near-flush with the door or drawer face, which supports projects that favor clean fronts without protruding knobs. The Schaub and Company branding ties this pull directly to a decorative hardware line focused on cabinet and furniture use.
The 3 inch center-to-center specification on this Schaub Sabre edge pull sets the distance between mounting points, which guides drilling operations on cabinet doors and drawers. The 4-1/4 inch overall length defines how far the pull runs along the edge, which affects how it aligns relative to stile widths or drawer side margins. The edge pull style indicates mounting at the top or side edge of a door or drawer front, keeping the grip close to the panel face. The #8 x 5/8 inch flat head sheet metal screw detail points to a countersunk mounting interface, which allows the screw heads to sit flush within the pull for a smooth feel when operating the cabinet.
The Schaub Sabre Edge Pull, 3 inch center-to-center, suits cabinet and furniture work where a slim grip along the edge keeps the front face mostly clear. The 4-1/4 inch length works well on typical kitchen and bath door rails, providing enough span for fingers while staying proportional on residential casework. As an edge pull, it naturally applies at the top edges of doors or the upper edges of drawers, creating a continuous line when several pulls are aligned side by side. The unlacquered brass surface supports projects that call for a living metal look, so the pull can visually track with brass hinges or other exposed components in the room.
The defined 3 inch center-to-center dimension lets installers work from a single drilling template, which helps keep hardware in line across long cabinet runs. The specified 4-1/4 inch length gives a predictable margin beyond the screw centers, which assists in positioning the pull so that edges and reveals read consistently from cabinet to cabinet. The #8 x 5/8 inch flat head sheet metal screw callout confirms a countersunk connection through the pull body, so the screw heads sit down into the metal and do not interfere with the hand when pulling. The unlacquered brass composition allows each pull to develop surface character where it is touched most, which can signal the primary touch points while still tying in with surrounding brass hardware.
The Schaub Sabre Edge Pull is an edge-mounted cabinet pull, so it grips from the door or drawer edge instead of projecting like a traditional handle.
The 3 inch center-to-center on this edge pull sets the hole spacing, which helps installers lay out consistent drilling across multiple fronts.
The Schaub Sabre Edge Pull measures 4-1/4 inches in overall length, giving extra gripping area beyond the 3 inch mounting span.
This Schaub edge pull is unlacquered brass, so bare brass is exposed and its appearance can change over time in the installed environment.
The Schaub Sabre Edge Pull uses #8 x 5/8 inch flat head sheet metal screws, creating a countersunk attachment through the pull body.
The 10010-UNBR part number identifies this specific Schaub Sabre Edge Pull in unlacquered brass with 3 inch center-to-center spacing.
The Schaub Sabre Edge Pull, 3 inch center-to-center in unlacquered brass, offers a defined hole spacing, a 4-1/4 inch length, and edge-mounted operation that support streamlined cabinet fronts. For projects built around living brass and precise alignment, this pull provides the dimensions and mounting format needed to keep hardware runs consistent from opening to opening.