Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schaub Turno pull is a traditional arch-profile cabinet pull that mounts on 4 inch (102 mm) centers, one of the most common two-hole patterns in kitchen and bath cabinetry.
The 4 inch center-to-center spacing is the standard for a broad range of upper cabinet doors, spice drawers, and narrow to mid-width drawer fronts. If the existing hardware runs 4 inch centers, this pull is a direct replacement with no new holes to drill. For a full kitchen or bath hardware change-out, the 4 inch spacing is flexible enough to run consistently across door and drawer fronts at multiple widths, which simplifies the hardware plan considerably. The arch profile fits naturally on raised-panel and frame-and-panel doors without competing with the door's own geometry.
The pull is finished in Light Bronze, a warm, mid-depth bronze tone with a softened surface that sits closer to an antique look than a polished one. It reads as a quiet warm metal in the room rather than a bright accent, which makes it easier to carry through a traditional kitchen without the hardware becoming the focal point. The arch form reinforces that restraint: the profile has visual weight, but it follows the curve rather than demanding attention. Note that Material Type is not populated in the source data for this SKU; do not assume the substrate from the finish name.
This pull suits cabinet makers, installers, and homeowners specifying hardware for a traditional or transitional kitchen, bath, or furniture piece where the finish program runs warm bronze tones. At 4 inch centers it is the practical choice for upper doors and smaller drawer fronts across a standard cabinet layout. Designers building a coordinated Turno program can pair this pull with the larger center-to-center sizes in the same collection for wider drawers and appliance fronts, keeping the profile and finish consistent across the full run of cabinetry.
Center-to-center is the drilling dimension: 4 inches (102 mm) between the centers of the two mounting holes. Overall length is 4-1/2 inches end to end, which is a size and clearance figure, not a drilling figure. Match the center-to-center to your existing or planned hole pattern.
Most cabinet manufacturers drill upper doors and smaller drawer fronts at 3-3/4 inch or 4 inch centers. Confirm your cabinet's actual hole spacing before ordering; 3-3/4 inch and 4 inch are similar but not the same, and the difference is enough to prevent a fit.
Light Bronze is Schaub's own finish name for this pull. Finish names are not standardized across brands, so a match between this finish and any other manufacturer's fixture finish cannot be confirmed without comparing samples in person.
The source data does not confirm included fasteners for this SKU. Check with your supplier or plan to source machine screws in the length appropriate for your door or drawer front thickness.
The Turno arch pull at 4 inch centers delivers a traditional profile in Light Bronze at the spacing that fits the widest range of standard cabinet doors and drawer fronts.