Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schaub Sorrento pull is a contemporary rectangular cabinet pull for doors and drawer fronts, sized for the 5-1/16 inch (128 mm) two-hole spacing that appears across a wide range of cabinetry.
The 5-1/16 inch (128 mm) center-to-center is one of the most common hole patterns in frameless and face-frame cabinetry alike. On a drawer bank already drilled to this spacing, this pull is a direct swap with no new holes required. For new construction or a full hardware refresh, it pairs naturally with mid-width base drawers, upper door pairs, and island fronts in the 12 to 18 inch width range where a pull of this scale reads in proportion rather than undersized. The slim projection keeps it out of the way on high-traffic runs like a row of base drawers.
The pull is cast in zinc and finished in Matte Black. The rectangular cross-section gives the face a flat, uninterrupted plane rather than the curved highlight a round bar produces, which suits flat-front and shaker-style doors where the hardware should align with the geometry of the cabinetry. Matte Black is a low-sheen finish that stays visually even under kitchen and bath lighting, neither picking up glare nor fading into the background on lighter fronts. It reads clearly against white and gray paint finishes and holds its contrast against natural wood tones.
This pull suits kitchen renovations, bath vanity updates, and built-in cabinet projects running a contemporary hardware program in black. Contractors retrofitting existing cabinetry drilled to 128 mm will find the spacing eliminates one of the more common friction points in a hardware swap. Designers specifying a full kitchen can run this pull on drawers and coordinate with knobs or complementary pulls from the Sorrento collection in the same finish. Homeowners replacing worn or dated pulls on a 128 mm hole pattern can match the existing layout without touching the face of the door.
Center-to-center is the drilling dimension: the distance between the centers of the two mounting holes, here 5-1/16 inches (128 mm). Overall length is the end-to-end size of the pull at 5-3/8 inches (137 mm). Matching existing holes means matching center-to-center, not overall length.
The projection is 1 inch (25 mm), measured from the door face to the back of the grip. This is a slim profile that keeps the pull close to the front.
Sorrento collection pieces in Matte Black share the same finish designation. As with any manufacturer's finish, confirm all companion pieces are from the Sorrento series before specifying a match.
Yes. The rectangular bar form and two-hole mounting are suited to both drawer fronts and cabinet doors at this scale.
When the hole pattern is already there and the hardware program calls for matte black, this Sorrento pull closes the gap between what the cabinet is drilled for and what the finished room should look like.