Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schaub Sorrento pull is a contemporary rectangular bar pull for cabinet doors and drawer fronts, mounting on 7-9/16 inch (192 mm) centers.
A 7-9/16 inch center-to-center is a long pull, and that length has a specific job. It works on wide base drawers, full-height pantry doors, and appliance-adjacent cabinetry where a shorter pull would look undersized relative to the front. It also handles the double-door situation cleanly: a single pull centered on a wide door spans enough of the face to give a confident grip. Cabinet shops and designers commonly reach for this spacing on base runs where the drawer stack is the visual anchor of the kitchen, and a proportionate pull is part of what makes that work.
The pull is cast in zinc and finished in Satin Nickel. Satin Nickel is a brushed surface with a measured, even sheen rather than the high glare of a polished finish. It reads as a cool silver in most lighting, which makes it easy to coordinate with stainless appliances, brushed chrome faucets, and similar fixtures without introducing a finish conflict. The rectangular cross-section keeps the grip face flat, so the pull sits in the same geometric plane as a slab or shaker front rather than introducing a curve.
This is the right choice for a contemporary kitchen, bath vanity, or media built-in where the hardware program is running in a silver tone and the fronts are wide enough to warrant a longer pull. It works equally well in a cabinet shop specifying hardware for a full kitchen run, a designer selecting coordinated pieces for a multi-room project, or a homeowner replacing a single large drawer pull and wanting it to land on existing holes. Because it belongs to the Sorrento collection, matching pieces in the same series are available for the rest of the cabinet run.
7-7/8 inches (200 mm) end to end. The center-to-center mounting spacing is 7-9/16 inches (192 mm), so the overall length runs slightly longer than the hole spacing.
1 inch (25 mm) from the door or drawer face to the back of the grip.
Yes. A 192 mm pull is a common choice for tall doors and pantry fronts where a shorter pull would look out of proportion.
Satin Nickel is a cool brushed silver tone that sits close to brushed stainless in most lighting conditions. Finishes vary by manufacturer, so a direct physical comparison is the best confirmation before ordering at volume.
When the drawer or door is wide enough to call for a 192 mm pull and the hardware program is running in Satin Nickel, this Sorrento piece covers both requirements in one selection.