Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune SWF-640 is a contemporary stainless steel bar pull for cabinet doors and drawer fronts, mounting on 4 inch (102 mm) centers.
A 4 inch center-to-center is a natural fit for upper cabinet doors, narrow drawer fronts, and bathroom vanity drawers where a 3-3/4 inch pull would be too compact and a 5 inch pull would overhang the front. It is a common spacing on production cabinetry, so this pull often drops onto existing holes without any new drilling. On a spec kitchen or a cabinet shop delivering finished boxes, the 102 mm spacing threads through the standard range with enough clearance on both sides to stay proportional. The slim 3/8 inch bar profile keeps the hardware quiet against slab and shaker fronts rather than competing with the door geometry.
The SWF-640 is constructed and finished in stainless steel, which means the substrate and the surface are the same material rather than a plated finish over a different base. Stainless steel holds its appearance without the patching or re-coating concerns that arise with a plated zinc pull over years of daily use. The surface reads as a consistent brushed or satin tone in the Silver Tone family, coordinating readily with stainless appliances, sinks, and fixtures already in most kitchens and baths. This is an indoor product; no exterior or marine suitability is stated for this SKU.
This pull suits designers specifying a contemporary kitchen or bath where the hardware program runs stainless throughout, cabinet shops building to a spec that calls for 102 mm centers at this scale, and contractors replacing existing pulls on production boxes already drilled to 4 inch spacing. Because the SWF series extends to longer center-to-center options, a single-family kitchen can run this pull on narrower drawers and step up to a longer SWF spacing on wide drawer banks, keeping the same bar profile and finish across the whole run.
Yes. 4 inches converts to 101.6 mm, which rounds to the 102 mm nominal value used in this pull's specification. The two figures refer to the same hole spacing.
Center-to-center is the drilling dimension: the distance between the centers of the two mounting holes, 4 inches on this pull. Overall length is the end-to-end size of the pull itself, 4-3/8 inches, which is always larger. Match your existing holes to the center-to-center figure, not the overall length.
Yes. A stainless steel pull is made from stainless steel through and through. A stainless-finish pull is typically a zinc or aluminum base with a plated or coated surface. The SWF-640 is stainless steel construction.
The SWF series is available in longer center-to-center spacings, so you can pair this 4 inch pull on narrower fronts with a longer SWF pull on wider drawers and keep the same bar profile and finish throughout.
Choose the SWF-640 when 4 inch centers fit the front, the hardware program is stainless, and the job calls for a bar profile that stays proportional without drawing attention to itself.
