Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Sugatsune SWF series pull is a contemporary cabinet pull in stainless steel, sized for the drawer widths and door fronts that dominate a standard kitchen or bath layout.
A 5 inch center-to-center is one of the more versatile mounting dimensions in a kitchen. It sits comfortably on 15 to 18 inch base drawers, works on standard 12 to 15 inch upper door fronts, and handles the narrow drawer stacks common in bathroom vanities. Where a 4 inch pull can feel undersized on a mid-width drawer and a 6 inch pull can crowd a smaller front, this spacing lands in the range that suits both without requiring a change of hardware across the run. The slim 3/8 inch bar keeps the footprint tight so the pull does not read as oversized on lighter-duty fronts.
The pull is machined from stainless steel and finished in its own material, which means the visible surface and the structural core are the same metal. There is no plated substrate underneath, no color coat on top, and no risk of the finish delaminating from the bar over time. The stainless surface takes on a consistent silver tone across the length of the bar, which holds its appearance under kitchen light without the variability that a brushed or tinted finish can introduce. It wipes clean without special care.
This pull suits a contemporary kitchen or bath where the hardware program runs in a single metal and that metal is stainless. It is a natural fit for a project that already specifies stainless appliances, stainless fixtures, or stainless countertop accessories, because the bar will read as part of the same material family rather than as a close match. Cabinet shops specifying a full run will find the SWF series available in other center-to-center sizes, so the same design language can carry across different drawer widths without mixing pull families. For a designer or contractor building a consistent hardware program, that range coverage removes a sourcing step.
Two screws through the door or drawer front at 5 inch (127 mm) centers. Confirm whether mounting hardware is included for your order, as fastener inclusion is not specified in the product data for this SKU.
Stainless steel is both the structural material and the finish surface on this pull. It is not a plated base metal.
Yes. The SWF series is available in additional center-to-center sizes, so you can carry the same profile across different drawer and door widths in one project.
A 5 inch center-to-center suits the narrow to mid-width drawers common in vanities. Confirm the drawer width and existing hole spacing before ordering if you are replacing hardware rather than drilling new holes.
Choose this pull when the project calls for a stainless bar at a 5 inch spacing, and the hardware should read as part of the kitchen's metal program rather than as a separate finish layer on top of it.
