Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Sugatsune SWF-660 is a stainless steel bar pull from the SWF series, designed for cabinet doors and drawer fronts where a 6 inch (152 mm) center-to-center spacing fits the scale of the front.
The 6 inch center-to-center is a practical mid-point in the SWF line. It is wider than a standard 4 or 5 inch pull but stops well short of the 9 and 12 inch appliance-scale sizes, which puts it in the range commonly used on base cabinet doors, medium drawers, and upper doors where a longer pull would look oversized. The 6-3/8 inch overall length keeps the bar proportional to that scale: enough visual presence to read clearly on the front, not so long that it competes with the cabinetry. The 3/8 inch bar width stays narrow, which reinforces the linear look rather than adding bulk.
Unlike pulls where stainless is a finish applied over a zinc or aluminum substrate, the SWF-660 is constructed from stainless steel, so the surface color and the base material are the same. The finish carries the Silver Tone quality of the metal itself rather than a plated or coated approximation. In a contemporary kitchen running stainless appliances, stainless cabinet hardware becomes a coordination tool: it picks up the same tone as the refrigerator and the range without introducing a second metal. The 1-3/8 inch projection keeps the grip well clear of the door face, which matters on a bar this narrow since there is no wide palm rest to compensate.
This pull is a natural fit for cabinet shops and designers running a contemporary or minimalist hardware program where the metal should stay consistent from the appliances to the cabinetry. The narrow bar and the clean stainless finish work on both slab and flat-panel fronts. At 6 inch centers it also suits renovation projects where a previous hardware run was drilled to that spacing and the replacement needs to drop onto existing holes. Because the SWF series includes other center-to-center sizes, a designer specifying a mix of drawer and door sizes can pull from one family across the whole project.
The SWF-660 is stainless steel construction, so the material and the finish are the same metal rather than a coating applied over a different substrate.
The projection is 1-3/8 inches (35 mm), measured from the mounting surface to the back of the bar.
Yes. The SWF series includes pulls in additional center-to-center sizes, so you can specify a consistent profile across different drawer and door widths on the same project.
A pull that mounts on 6 inch (152 mm) centers will align with existing holes drilled to that spacing. Measure between the centers of your existing holes to confirm before ordering.
When the project calls for a 6 inch center-to-center in a narrow stainless bar, the SWF-660 delivers the profile without the bulk, and the material without the plating.
