Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune SWF-6120 is a stainless steel bar pull in the SWF series, designed for cabinet doors and drawer fronts where 12 inch center-to-center spacing puts the hardware in scale with the opening.
A 12 inch center-to-center pull is scaled for the widest cabinet fronts in a kitchen or a built-in: deep base drawers, double-door pantries, appliance garage doors, and full-height wardrobe panels. At this spacing, the pull spans enough of the front to feel proportional rather than undersized, and the single long bar replaces the visual noise of two smaller pulls on the same face. On a wide drawer bank, running this pull end to end on each front creates a continuous horizontal line across the run, which is the effect that drives the choice more than any individual pull specification.
The SWF-6120 is made from stainless steel, which means the base material and the finish are one and the same rather than a coating applied over a separate substrate. The surface carries a consistent brushed character across the flat face and the narrow 3/8 inch profile, and it reads as Silver Tone in most kitchen lighting without tipping into a polished or mirrored appearance. Stainless is a practical choice for cabinet hardware that sees frequent contact because it does not chip, flake, or wear through to a different color underneath.
This pull suits cabinet shops, designers, and contractors specifying contemporary kitchens, baths, or custom built-ins where the hardware program runs stainless or brushed silver and the fronts are wide enough to call for a longer pull. It is also a straightforward replacement choice for any existing installation drilled on 12 inch centers, since the 305 mm spacing is standard at this scale. Homeowners renovating a kitchen with deep base drawers or tall pantry units will find this spacing proportional in a way that shorter pulls at the same scale would not be.
The 12 inch (305 mm) figure is the distance between the centers of the two mounting holes, which is what you match to existing holes or lay out when drilling new ones. The overall length is 12-3/8 inches (314 mm), slightly longer to account for the end caps and posts beyond the holes.
Stainless steel is the base material itself. Unlike plated finishes, it is not a coating applied over zinc or another substrate.
Yes. At 12 inch centers it is particularly well suited to wide drawer fronts and tall or wide door fronts where a shorter pull would look undersized relative to the face.
Yes. The SWF series is available in additional center-to-center spacings for smaller drawers and doors, so you can run the same profile across an entire cabinet program at different sizes.
When the front is wide enough that a shorter pull would read as an afterthought, the 12 inch SWF-6120 puts the hardware in proportion with the cabinetry and holds a clean stainless line across the run.
