Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Pro Value Series 20 inch side-mount ball bearing drawer slide delivers smooth, reliable travel in a bright zinc finish. Rated 75 lb per pair with a 3/4-extension travel range and a hold-in detent that keeps the drawer closed until pulled, it covers the workload of everyday kitchen, office, and utility cabinetry without unnecessary complexity.
The 3/4 extension range is a practical fit for drawers where everyday front-of-drawer access matters more than reaching all the way to the back wall — think utensil drawers, shallow bathroom vanities, and closet built-ins where the contents are shallow or front-loaded. It is also a solid choice for drawer boxes in production runs where cost efficiency and consistent fit matter more than full rear access. The hold-in detent adds value in any install where a hard close could otherwise bounce the drawer back open — high-traffic kitchens, workshops, and office cabinets all benefit from the stay-closed behavior without needing a spring or damper mechanism.
Steel members carry the load and the bearing raceways, keeping the slide rigid under the rated 75 lb per pair. The bright zinc plating is the segment standard for indoor slide hardware — it resists light corrosion in dry cabinet interiors and blends with white, almond, and natural wood melamine liners. Zinc is a functional finish rather than a decorative one; the slide rides alongside the drawer box and stays largely out of sight during normal use. This is an indoor slide; for damp or exterior applications, a different finish or material is required.
Cabinet shops running production volume will find the non-handed design and standard 1/2 inch side clearance keep installation straightforward — no sorting left from right, and drawer boxes built to the same formula across every opening. Designers specifying vanity, closet, or laundry cabinetry where full rear access is not a priority get honest 3/4 extension performance at a value price point. For face-frame cabinet builds, rear mounting brackets are required to support the back end of the slide and are sold separately; the front slotted hole accommodates direct face-frame mounting on the cabinet member.
The drawer opens approximately three-quarters of the slide's 20 inch length. The rear portion of the drawer box stays inside the cabinet at full open. If complete access to the back of the drawer is a requirement, a full-extension slide is the right choice.
The hold-in detent is a mechanical catch that holds the drawer in the closed position until intentionally pulled. It prevents the drawer from bouncing back open after a firm close. It does not pull the drawer shut on its own and does not slow the close — it simply holds the drawer where you leave it.
No. The design is non-handed, so both slides in a pair are identical. Order the quantity your drawer count requires without sorting sides.
The slide requires 1/2 inch of side clearance per side. Build the drawer box 1 inch narrower than the cabinet opening to leave the correct gap for each slide.
Yes, with the appropriate rear mounting brackets to support the back end of the slide. The rear brackets for this series are sold separately. In frameless cabinets the slide mounts directly to the cabinet side panel.
The Pro Value Series 20 inch zinc ball bearing slide gives you honest 3/4 extension performance, a stay-closed detent, and a non-handed format that keeps production moving — all in a standard fit that drops into most side-mount drawer builds without modification.
Sold In: 10 Set
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1000 Each |  WW46000 Mfr# 3670000235961 1000 | Würth #8 x 7/16" Truss Head Hinge and Drawer Slide Installation Screw Phillips Drive - Sharp Point Coarse Thread Zinc, 3670000235961 1000 - 1000/Box |