Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #8-32 x 2" truss head machine screw is built for mounting cabinet knobs, pulls, and decorative hardware to thicker door and drawer front stock where a standard-length machine screw comes up short. The 8-32 thread is the North American cabinet hardware standard, so this screw fits virtually any knob or pull without hunting for a compatible size.
Most cabinet hardware ships with a 1-inch or 1-1/4-inch machine screw, which works fine on a plain 3/4-inch door. The 2-inch length steps in when the installation is deeper than that: a thick slab drawer front, a cabinet door with applied molding, a double-stacked panel, or a drawer front with a decorative overlay. At 2 inches, the threaded shank has enough reach to pass through the full stock thickness and still engage the knob or pull base completely. The truss head's wide, flat bearing surface distributes the clamping force evenly on the back face of the panel, which matters when the material behind the hardware is a finished laminate or a thinner overlay piece that a smaller head might dig into.
The zinc finish protects the steel shank in the dry indoor environments where cabinet hardware lives. It keeps the screw from picking up surface rust in a humid shop or a kitchen cabinet interior without adding bulk to the shank diameter. The 8-32 fine thread engages cleanly in pre-tapped hardware shanks and threaded bushings, and the blunt point starts without scoring the inside of a clearance hole. Because machine threads are cut to a controlled pitch, the connection stays repeatable when hardware is removed and reinstalled during a renovation or hardware swap.
Cabinet installers and finish carpenters who regularly work with thick European-style slab fronts, raised-panel doors with significant build-up, or custom drawer fronts with applied banding find a box of 2-inch 8-32 screws solves the one frustrating gap in a standard hardware kit. Designers specifying oversized pulls on thick stock can call out this length with confidence that the shank will have full engagement. For shops that process a mix of door thicknesses, keeping this length on hand alongside a standard 1-1/4-inch screw covers nearly every residential and light commercial hardware install without custom sourcing. Packed 100 to the box, the quantity suits a single large project or serves as restocking inventory for a production shop.
The truss head is wider and lower in profile than a standard pan head. That extra width spreads clamping load across a larger footprint on the back of the panel, which helps prevent the head from digging into finished surfaces or thin overlay materials when the screw is tightened.
Either works. The combination recess accepts a #2 Phillips driver or a flat-blade driver, so you can use whatever is already in your hand without switching bits.
8-32 is the thread standard used by virtually all North American cabinet hardware manufacturers for knobs and pulls, so it will fit standard hardware without adapter bushings or size matching.
Add the thickness of your door or drawer front to the depth of the knob or pull base. The screw needs to pass fully through the panel and engage the full threaded section of the hardware. For a 1-1/2-inch slab front with a standard pull base, a 2-inch screw typically provides the right engagement. Thinner stock usually calls for a shorter length.
The zinc finish is rated for dry indoor environments. For exterior hardware or areas with ongoing moisture exposure, a stainless steel machine screw is the better choice.
When the standard screw in the hardware bag is too short, the Würth #8-32 x 2" truss head machine screw closes the gap cleanly, with the right thread, the right head, and enough length to handle the thicker stock that shows up in real installs.
Sold In: 100 Each
