
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
The Würth #8 x 1-1/8" washer head installation screw is a coarse-thread fastener designed for attaching cabinet hardware, hinges, drawer slides, and mounting plates to wood and engineered panel substrates. The 1-1/8" length is well matched to shallow panel installations where a longer screw would over-penetrate.
At 1-1/8", this screw is sized for hardware mounting situations where panel thickness limits how deep a fastener can go. Typical applications include attaching hinge mounting plates and drawer slide brackets to 3/4" cabinet panels, securing face-frame clips to cabinet boxes, and fastening hardware backing plates where a longer screw would exit the back face of the panel. The washer head seats cleanly against hardware flanges and mounting plates without requiring a countersink, which keeps installation straightforward in production and site work alike.
The zinc finish provides galvanic protection suited to dry interior environments. This screw belongs inside the cabinet box, in the shop, or on the bench, not on an exterior application or anywhere moisture is a factor. The #8 gauge gives the shank enough cross-section to resist the side loads that come with hinge cycling and drawer slide use, while the coarse thread pulls cleanly into wood fiber and engineered panel material.
Cabinet installers working from a pouch or a driver caddy will appreciate the combination drive: the same recess accepts a #2 Phillips or a #2 square bit, so there is no need to swap bits when moving between different drivers on the job. For production shops running hardware installation at volume, the 6,500-piece box reduces replenishment interruptions. The sharp point and coarse thread let the screw start and seat quickly in pre-drilled or undrilled wood substrates, keeping the line moving.
Yes. The washer head seats flat against hinge mounting plates and drawer slide brackets, and the 1-1/8" length is appropriate for hardware mounted to standard 3/4" cabinet panels without over-penetrating.
The drive recess accepts both a #2 Phillips and a #2 square bit. Use whichever is in your driver. A correctly sized bit gives the best engagement in either drive orientation.
No. The washer head is a non-countersunk profile designed to bear flat against the surface of a mounting plate or panel face, so no countersink preparation is needed.
The coarse thread provides good engagement in particleboard and MDF. For best results in very low-density panels, pre-drilling into the edge is advisable to protect the material around the hole.
No. Zinc plating is suited to dry indoor environments. For outdoor, humid, or wet-area applications, choose a screw with a heavier corrosion-resistant coating.
When the job calls for a short, reliable hardware screw that starts fast, sits flat, and works with the bits already in your kit, the Würth 1-1/8" washer head installation screw is a straightforward choice for cabinet shops and installers.
Sold In: 6000 Each