Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Blum CLIP top hinge is built for half overlay cabinet doors on both face-frame and frameless cabinets, opening to 120 degrees and mounting via press-in dowels for a clean, screw-free cup installation. It closes with a self-close spring and carries a nickel finish throughout.
A 120-degree opening is the right call when the extra clearance matters: corner base cabinets where a taller door swings close to an adjacent wall, pantry runs where a wider arc keeps the door clear of stored items, or any double-door cabinet where the extra swing makes reaching the full interior comfortable. The half crank arm handles the geometry for two doors meeting on a shared partition, each overlapping the cabinet side by a half overlay rather than covering it fully. The 35mm cup bores into the back of the door in the standard pattern, and the arm clips to a Blum base plate on the cabinet, which is ordered separately and specific to Blum's CLIP top system.
The dowel cup attachment presses into pre-bored 8mm dowel holes in the door with no cup screws, which keeps CNC-drilled production doors moving through the line without a fastening step at the door side. The hinge body is plated steel. Nickel is a neutral, hardware-friendly tone that pairs naturally across the full range of cabinet pulls, knobs, and slides without committing to a warm or cool direction. The self-close spring draws the door shut but does not cushion the landing; if the project calls for a damped, quiet close, the BLUMOTION soft-close version of this series is the appropriate selection.
Cabinet shops running CNC equipment will find the dowel cup a time saver across volume runs, eliminating cup screws without sacrificing holding strength. Remodelers and contractors replacing existing half overlay hardware on face-frame kitchens can match the overlay and opening angle without reworking the door boring, provided the existing holes follow a standard pattern. This hinge works equally on frameless boxes, so it suits a mixed run of frameless and face-frame work from the same order. Standard door thickness runs 16 to 22mm; doors outside that range call for a thick-door or thin-door hinge instead.
Yes. The hinge arm clips to a Blum base plate that mounts to the cabinet, and the plate is a separate purchase. Use a Blum CLIP top plate matched to your cabinet construction and the overlay you need.
Self-close. A spring pulls the door shut over the last few degrees of travel, but there is no damper to slow the close. For a cushioned, quiet close, select the BLUMOTION soft-close version of this series.
The cup carries pre-attached dowels that press into pre-bored holes in the door, so no cup screws are needed. Your door needs standard 35mm cup boring plus the matching dowel holes; most CNC programs include this as a standard operation.
No. Blum CLIP top hinges connect to Blum plates only. Plates from other manufacturers will not engage the CLIP top arm.
Specify this hinge when half overlay doors need a wider arc, dowel cup installation fits your production process, and nickel is the finish tying the hardware together.
Sold In: 1 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  BP71T5650 Mfr# 71T5650 | Blum CLIP top 120° Half Overlay Hinge Self-Closing Screw-On Nickel-Plated 71T5650 | ||||
Sold in: 1 Each |  BP71T5690B Mfr# 71T5690B | Blum CLIP top 120° Half Overlay Hinge Self-Closing INSERTA Nickel-Plated 71T5690B |
