Blum CLIP Concealed Hinge in Nickel for Full Overlay Doors at 100 Degrees

This Blum CLIP self-close hinge mounts full overlay doors on both face-frame and frameless cabinets, opening to 100 degrees with toolless INSERTA plate mounting and a nickel finish.

Key Features

• Self-close spring pulls the door shut over the last few degrees of travel so it latches every time.
• 100 degree opening angle provides controlled swing suited to wall-adjacent or space-conscious installations.
• Full overlay straight arm positions the door to cover nearly the entire cabinet side, leaving only a narrow reveal.
• INSERTA tool-free plate mounting presses the base plate into pre-drilled 5mm system holes without screws.
• Three-way adjustment lets you dial in height, side, and depth after the door is hung.
• Nickel finish on plated steel blends with brushed and satin hardware across the cabinet run.

A Measured Swing for Full Overlay Work

Where standard hinges open to 110 degrees, this hinge opens to 100 degrees, a deliberate choice that suits cabinets positioned near a wall, a refrigerator column, or an adjacent tall unit where a wider arc would put the door edge into an obstruction. The full overlay straight arm keeps the door covering the cabinet side as expected, and the self-close spring draws it shut reliably from a few degrees out. The 35mm cup bores into the back of the door at the standard 45mm bore pattern, and the arm connects to a separate Blum base plate on the cabinet, which is sold separately and matched to your cabinet construction.

Nickel Finish and a Dependable Spring Close

The hinge body is plated steel with a nickel finish, a neutral tone that pairs naturally with satin nickel pulls, bin cups, and drawer slides across a kitchen or bath run. Self-close is the practical workhorse of the concealed hinge category: no damper to wear out, just a consistent spring pull that closes the door without any assist. For a project that does not need cushioned closing and wants a reliable, low-maintenance mechanism, this is the right specification.

Where This Hinge Belongs

This hinge fits face-frame and frameless cabinets alike, which makes it straightforward to specify across a mixed job. INSERTA mounting requires the cabinet to have pre-drilled 5mm system holes at the standard spacing; for boxes without those holes, the screw-on plate version of this CLIP hinge is the right substitute. The 100 degree opening is well matched to wall cabinet runs where a door opened fully would contact the wall or the cabinet next to it. Cabinet shops, finish carpenters, and remodelers installing nickel hardware throughout will find this hinge a consistent fit from the first box to the last. For doors thicker than about 22mm, a thick-door hinge is the appropriate choice instead.

Common Questions

Full Overlay Doors That Close on Their Own, Right Where You Need Them

Specify this hinge when the job calls for full overlay doors in nickel that self-close reliably and open to a controlled 100 degree arc, on face-frame or frameless cabinets with 5mm system holes.