Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rev-A-Shelf LD-4NW lazy susan ships as a bulk pack of eight 28-inch full-circle maple wood trays, each rotating independently, sized for cabinet shops and contractors finishing multiple corner cabinets in a single project run.
Corner base cabinets are the hardest storage space to use well. A full-circle lazy susan turns dead corner real estate into rotating, accessible storage where nothing gets buried at the back. At 28 inches across, these trays fill the corner opening with usable surface rather than wasted air. Because each tray rotates independently, a cook can spin the bottom shelf to reach a jar without displacing what is sitting on the upper shelf. That independent motion is especially useful in a cabinet shared by more than one person, where the top shelf might hold one category of goods and the lower a different one entirely.
The trays are built from maple and arrive prefinished, so cabinet installers can drop them into the cabinet without a finishing stop. Maple is a close-grained hardwood that takes wear from sliding cans and shifting jars without showing it quickly. The prefinished surface keeps the look consistent across a multi-cabinet kitchen without requiring the installer to match a stain on site. At 2 inches in height per tray, the profile stays low enough to leave vertical clearance for typical pantry and canned-goods storage.
A pack of eight trays suits a cabinet shop running a full kitchen, a contractor installing corner cabinets across multiple units in one job, or a distributor stocking for repeat orders. Buying in a set rather than one tray at a time reduces per-unit cost and eliminates the gap between ordering and arrival that can hold up finishing work. These are trays only, so the bearing and pole assembly — if not already on hand — should be sourced alongside this pack. The floor-mount position and drilled configuration make these compatible with standard LD-4NW series hardware.
No. This pack is trays only. The center pole and bearing assembly are sold separately and need to be on hand before installation.
Yes. The trays arrive drilled for the center pole, consistent with the LD-4NW series configuration, so no field drilling is required for the pole opening.
The trays are prefinished maple and install as-received. No sanding, staining, or topcoat is needed.
Each tray sits on its own bearing point and spins without moving the others. Spinning the lower tray does not rotate the upper tray, so contents on both levels stay put until you choose to move them.
For a cabinet run where corner storage needs to work and the finish has to match, this bulk pack of prefinished maple trays keeps the job moving without a trip back to the supplier for more.
Sold In: 8 Each
