Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Sugatsune 16 Series pull is a stainless steel bar pull for cabinet doors and drawer fronts, mounting on 3-3/4 inch (96 mm) centers — one of the most widely drilled spacings in residential and commercial cabinetry.
The 3-3/4 inch center-to-center spacing has been one of the dominant hole patterns in cabinetry for decades. It appears on production kitchen cabinets, bath vanities, and case goods from most major manufacturers, which makes a pull at this spacing the most likely candidate for a direct swap on an existing installation. When a job calls for replacing hardware without re-drilling, 96 mm is typically the first spacing to check against. The 4-5/8 inch overall length clears the mounting holes by roughly 7/16 of an inch on each end, giving the bar a clean overhang without crowding the face frame or door edge.
The 16 Series pull is made from stainless steel, which distinguishes it from the zinc and zinc-alloy construction that covers the majority of bar pulls at this price point. Stainless steel is a single material through and through — the surface is not a plated finish applied over a softer substrate. The result is a Stainless Steel finish that maintains its brushed, silver-tone appearance without the risk of plating wear at the grip area over time. The 1/2 inch bar width keeps the profile narrow and architectural, reading as a precise line on the door face rather than a bulky grip element.
At 96 mm centers this pull works equally well in a kitchen drawer bank, across a run of upper cabinet doors, or on a bath vanity. The narrow bar and satin stainless finish are well matched to contemporary flat-front cabinetry, and the Sugatsune 16 Series is a recognized name in specification and commercial work where dimensional consistency and material quality are both requirements. It is also a practical choice for a residential renovation where the existing hole pattern is 96 mm and the goal is hardware that holds up to daily use without a finish that can chip or flake. Because the pull is part of a larger series family, companion pulls in different center-to-center sizes carry the same profile, width, and finish, which makes it straightforward to run a consistent hardware program across mixed drawer and door widths.
The Material Type is stainless steel, meaning the pull itself is stainless steel, not a plated finish over zinc. The surface appearance and the base material are the same.
If the distance between the centers of your existing holes is 3-3/4 inches (96 mm), this pull mounts on that pattern. Measure between hole centers, not between hole edges, to confirm.
The 16 Series is available in multiple center-to-center sizes, all sharing the same bar profile and Stainless Steel finish, so mixing lengths across a project gives a consistent look even where drawer widths vary.
The bar is 1/2 inch (13 mm) wide, a narrow profile that keeps the hardware from visually competing with the door or drawer face.
This pull delivers stainless steel quality at the center-to-center measurement where most cabinetry is already drilled, making it an efficient upgrade or direct replacement for a wide range of installations.
Sold In: 1 Each
