Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Schaub and Company Traditional Designs pull is a solid brass bar pull designed for cabinet doors and drawer fronts, mounting on the most common cabinet hole spacing in residential cabinetry.
The 3 inch center-to-center spacing is the baseline hole pattern across a wide range of production cabinetry, stock cabinet lines, and older custom work. That makes this pull the practical choice for a straightforward hardware swap: if the existing holes are on 3 inch centers, this pull drops in without any redrilling. It also means it suits smaller drawer fronts, upper door pulls, and situations where the hardware footprint needs to stay compact relative to the front's width. On a shaker or raised-panel upper cabinet door, a pull of this proportion reads as a considered finish rather than an oversized fixture.
The pull is constructed from solid brass and finished in Antique Brass, a warm, darkened gold tone with depth rather than uniform brightness. An antique brass finish carries some variation across its surface, which gives it the character that suits traditional and transitional cabinetry better than a polished or brushed alternative would. The solid brass substrate means the finish is applied over the same metal the piece is made from, rather than over a zinc or alloy casting, which affects how the surface ages and how it feels when handled. Within the Traditional Designs series, the finish is consistent across companion pieces so knobs and pulls drawn from the same collection will read as a matched set.
This pull is the right choice for traditional and transitional kitchens, bath vanities, hutches, and built-in cabinetry where the hardware program calls for an antique brass finish and the existing hole pattern is 3 inches on center. It is equally useful for a cabinet shop fitting out a full kitchen with production-drilled boxes and for a homeowner replacing worn hardware on a cabinet run that was drilled to the 3 inch standard. Because the Traditional Designs series covers multiple center-to-center sizes, a mixed installation with larger pulls on wide drawers and this pull on doors or smaller drawers can be sourced from one collection in one finish.
This pull is solid brass construction, not a plated zinc or alloy casting. The Antique Brass finish is applied over a brass substrate.
The projection is 7/8 inch (22 mm), which is the clearance between the door face and the back of the grip bar.
The Traditional Designs series is available in multiple center-to-center sizes in Antique Brass, so matching pulls at different lengths within one finish and collection is straightforward.
Antique brass finishes vary between manufacturers. This finish will coordinate with other Traditional Designs series pieces, but it is not guaranteed to match another brand's antique brass.
For cabinetry drilled on 3 inch centers where the hardware should carry a warm antique brass tone and solid brass feel, this pull closes the gap between a production hole pattern and a finish that reads as crafted rather than off-the-shelf.