Polished nickel pull 4 c c describes a solid brass handle from Schaub and Company designed for decorative cabinet use with a precise 4 inch center to center mounting span, so hole spacing lines up easily on standard cabinet layouts. The Traditional Series identity ties this pull to a classic styling family, which helps maintain visual consistency across multiple doors and drawers in the same room. The polished nickel finish provides a bright metallic surface, giving cabinetry a clean, reflective look that suits both traditional and transitional designs. The pull length of 5-1/8 inches leaves finger room beyond the 4 inch fastener spacing, which supports a comfortable grip when opening heavier cabinet fronts. A projection of 1-1/8 inches holds the hand away from the door face, reducing knuckle contact against finished surfaces during repeated use in kitchens, baths, or shop cabinets.
The 4 inch center to center dimension sets the distance between mounting points, which matches a common drilling pattern on cabinet doors and drawers for pull replacements or new layouts. The overall length of 5-1/8 inches provides edge clearance beyond the fastener locations, which helps keep the handle visually centered while still leaving wood around the holes for structural strength. A projection of 1-1/8 inches defines how far the pull stands off the surface, which offers finger clearance for different hand sizes without extending excessively into walk paths around cabinet runs. The specified 8-32 x 1 inch screw size aligns with typical cabinet construction, which supports straightforward attachment through standard thickness fronts.
The Traditional Series, solid brass construction, and polished nickel finish position this Schaub and Company pull as a decorative hardware choice for cabinet doors and drawers where a classic metal look is desired. The 4 inch center to center spacing matches a widely used handle pattern, which makes it suitable for installations where existing 4 inch holes already exist or where new drilling templates are set to that spacing. With an overall length of 5-1/8 inches, the pull covers the mounting area while still showing surrounding door or drawer material, which supports proportioned placement on both narrow and wider fronts. The 1-1/8 inch projection keeps the gripping area away from the face of the cabinet, which is useful when doors must open fully next to adjacent cabinets or appliances.
The clearly defined 4 inch center to center measurement allows installers to use standard 4 inch drilling jigs, which supports consistent alignment of multiple pulls across long cabinet runs. The 5-1/8 inch overall length provides a fixed reference when laying out hardware relative to door edges, which helps maintain uniform visual spacing across upper and lower fronts. The solid brass material adds weight to the pull body, which can assist in smooth-feeling operation of doors and drawers during repeated opening cycles. The polished nickel finish specification makes finish selection straightforward when coordinating with hinges or other decorative pieces labeled as nickel, supporting a cohesive hardware scheme throughout the project. The 8-32 x 1 inch screw size detail gives a known thread and length for installation planning, which simplifies preparation for mounting into standard cabinet stock.
The pull has a 4 inch center to center dimension, which sets hole spacing and aligns with common cabinet drilling patterns for handles using that span.
The pull length is 5-1/8 inches, which covers the 4 inch mounting holes while leaving surrounding cabinet material visible for balanced proportion.
The Schaub and Company 742-PN pull is made from solid brass, which provides a dense metal feel when operating cabinet doors and drawers.
This pull uses a polished nickel finish, which delivers a bright, reflective metal appearance that matches other nickel decorative hardware.
The pull has a 1-1/8 inch projection, which sets how far it stands off the cabinet face and provides finger clearance for gripping.
The web description lists 8-32 x 1 inch screws, which defines the thread and length used to fasten the pull through typical cabinet fronts.
This traditional series solid brass polished nickel pull combines a 4 inch center to center span, 5-1/8 inch length, and 1-1/8 inch projection, so it fits common cabinet drilling patterns while providing comfortable clearance and a coordinated nickel finish across your project.