polished aluminum inside corner 863P is a New York Metal edge molding designed as an aluminum cove for countertop back splashes and similar runs where an inside rounded corner is needed. The aluminum cove profile forms a smooth inside transition, which reduces sharp angles along the joint between vertical backsplashes and adjacent surfaces. This 1/16 inch cove molding creates a tight, clean radius that helps follow inside corners consistently along the length of the countertop or wall edge. The metal edge molding construction suits projects where a defined, durable corner detail is specified instead of open joints. A standard length of material at 12 ft lets installers bridge long stretches of backsplash or wall intersection in one continuous piece, which simplifies layout while keeping visual breaks to a minimum along the run.
This aluminum cove molding with a 1/16 inch profile is intended to form an inside rounded corner where a backsplash or similar surface meets another plane. The small-radius cove helps the installer position the molding tight into the joint, so the formed curve follows the inside corner without large gaps. The standard 12 ft length supports layout from one end of a backsplash field to the other, letting cuts be planned at ends or transitions instead of mid-span. As a metal edge molding, it can be aligned with other metal trim segments in the same area, which keeps the visual line of the corner consistent from one piece to the next along the installation.
Aluminum coves are used for countertop back splashes and other applications where an inside rounded corner is desired, so this molding fits locations where a vertical splash meets a horizontal or adjoining surface. By presenting a formed radius instead of a sharp angle, the cove molding defines the interior corner as a continuous curve. The 1/16 inch cove molding dimension helps it sit close to the intersection line, so the curve tracks the corner instead of projecting far into the work surface area. Because the standard length of material is 12 ft, the molding can extend across long countertop or wall sections in one piece, which reduces the number of cut joints that need to be aligned at intermediate points along the backsplash.
The 1/16 inch cove molding profile provides a known inside radius, which helps installers repeat the same visual corner detail from one project to another when the same New York Metal edge molding is specified. Using aluminum coves for countertop back splashes gives a defined metal geometry at the intersection, so the transition remains consistent with other metal edge moldings on the job. The standard 12 ft length is useful when planning repeatable shop cuts from stock, because a single length can be measured and cut to multiple shorter segments while preserving the same cove profile on every piece. The manufacturer part 141PH designation further supports repeatability, since orders that call out this part number will reference the same polished aluminum inside corner 863P configuration each time.
This aluminum cove molding is used for countertop back splashes and other locations where an inside rounded corner is desired, giving a formed metal radius at the intersection.
The 1/16 inch cove profile creates a compact radius that closely follows the inside corner line, producing a subtle curve without projecting far into the adjacent surfaces.
The polished aluminum construction provides a defined metal edge molding at the corner, matching projects that specify metal trim for backsplashes and similar intersections.
The 12 ft standard length allows long backsplash or wall runs to be handled with fewer joints, supporting straighter alignment and a more continuous corner line.
This molding is identified as POLISHED ALUM-INSIDE CORNER-863P by New York Metal with manufacturer part 141PH, providing a consistent reference on drawings and orders.
This item falls under metal edge moldings and aluminum coves, fitting projects where metal trim defines inside corners on backsplashes or similar surfaces.
This polished aluminum inside corner 863P cove molding gives countertop back splashes and similar intersections a consistent 1/16 inch radius along the joint. The 12 ft standard length and New York Metal 141PH identification support straightforward planning, cutting, and repeat ordering when the same inside corner detail is required across multiple runs or projects.
Sold In: 1 Each