Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National Signature Series chimney is a decorative wood chimney section designed to close the gap between a Signature Series wood range hood cover and the ceiling, completing the built-in look of the hood installation in hickory.
When a range hood cover does not reach all the way to the ceiling, a chimney section is the piece that fills that vertical run. Without it, the installation reads as incomplete, with an open gap above the hood body. This chimney mounts to the wall above the Signature Series hood cover and carries the same hickory profile upward, so the finished column of wood reads as one continuous element from the hood opening to the ceiling line. The result is a custom, built-in appearance rather than a floating appliance.
Hickory is one of the more visually active domestic species, with strong grain patterns, natural color variation, and occasional knots that give finished kitchens a warm, rustic energy. This chimney section arrives unfinished, which is the practical choice when the adjacent hood cover and cabinetry need to be finished together for a consistent match. Stain, paint, or a clear finish can all be applied after installation, using the same products used on the rest of the kitchen to keep the color and sheen aligned.
This section is the right choice for a kitchen where hickory cabinetry or an existing Signature Series hickory hood cover establishes the species, and where ceiling height requires an extension above the hood body to close the wall. Designers specifying a hood-to-ceiling run and cabinet shops finishing a complete hood assembly will both find it a straightforward fit. Because the chimney arrives unfinished, it is suited to job sites where the painter or finisher is handling the hood, cabinets, and trim together in a single finishing pass, keeping the color language consistent throughout the kitchen.
No. This is a decorative wood chimney section only. It does not include a blower, ventilator, or any air-moving hardware. The ventilation unit for the hood is selected separately and installed inside the hood cover, not the chimney.
This chimney is matched to the Signature Series. Compatibility with other Omega National series should be confirmed against the specific hood cover you are installing before ordering, since chimney profiles and attachment points can vary between series.
It arrives unfinished and ready to accept stain or paint. Finishing is done on site after installation so the chimney can be matched to the adjacent hood cover and cabinetry.
Hickory has natural color variation and an open grain that can absorb stain unevenly without a pre-conditioner. A wood conditioner applied before staining helps even the uptake. Test the finish on a scrap piece or a hidden surface first to confirm the result before finishing the full chimney.
A chimney section is a small part of the overall hood installation, but it is the piece that makes the assembly look intentional from floor to ceiling. In hickory, finished to match the surrounding kitchen, it pulls the whole run together.
Sold In: 1 Each
