Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National Signature Series chimney extension connects a Signature Series wood range hood cover to the ceiling, closing the gap between the hood body and the ceiling line in solid cherry wood. It mounts to the wall and is supplied unfinished, ready to accept stain or paint to match the surrounding cabinetry.
A wood range hood cover frames the cooktop area, but the hood body itself rarely reaches the ceiling. The chimney extension is the piece that fills the vertical run from the top of the hood up to the ceiling plane, giving the installation a finished, built-in appearance rather than leaving an open gap. This chimney is sized for a 48-inch-wide Signature Series hood and can be trimmed down to fit the actual ceiling height in the room. Because it mounts to the wall, it stays stable once set and reads as a continuous vertical element from hood to ceiling.
The chimney is built from cherry, which brings a warm, consistent grain pattern that pairs naturally with cherry cabinet runs. Because it ships unfinished, the finisher can apply the same stain or topcoat used on the surrounding cabinets and the hood cover, so the entire wall reads as one coordinated piece. Cherry accepts a range of stains well and develops a warm amber tone over time that distinguishes it from lighter species.
This piece is the right choice for a kitchen with a 48-inch Signature Series wood hood cover in cherry, where ceiling height leaves a gap the hood body cannot reach on its own. Cabinet shops finishing a full cherry kitchen, designers specifying a coordinated hood-to-ceiling detail, and contractors completing a hood installation all use this chimney the same way: trim it to the room's ceiling height, finish it to match, and fasten it to the wall above the hood. It is the decorative enclosure, not a ventilation component. The hood cover and the ventilation unit are separate products and are not included.
No. This is the chimney extension only. The Signature Series wood hood cover and any ventilation insert or power pack are separate products ordered independently.
Yes. The chimney is trimmable, so it can be cut to the exact height the room requires during installation.
It ships unfinished. Stain, paint, or any other finishing system can be applied on site to match the cabinets and hood cover.
It is matched to the Signature Series and is designed to coordinate with 48-inch Signature Series wood range hood covers in cherry.
When a cherry kitchen calls for a seamless run from the hood cover to the ceiling, this Signature Series chimney supplies the wood, the width, and the trimmable height to close that gap cleanly and finish to match.
Sold In: 1 Each
