Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg SML-F125 is a #7 x 1-1/4 inch pocket-hole and face frame screw sized for joining 3/4-inch hardwood stock. Fine thread, a washer head, a Type 17 auger point, and a square drive work together to pull hardwood face frame joints tight without splitting the stock.
At 1-1/4 inches, this screw is matched to the standard pocket-hole joint in 3/4-inch stock. That length puts enough thread into the receiving piece to hold the rail-to-stile or face-frame-to-box joint firmly, while staying well short of breaking through the opposite face. Shops building kitchen, bath, or furniture cabinets with hardwood face frames in maple, oak, cherry, hickory, or walnut will find this size lands right for that material thickness. It also works for attaching a finished face frame to the cabinet box when both pieces are 3/4-inch stock.
Fine thread is the correct choice any time hardwood enters the joint. Coarse threads act like a wedge in tight-grained species and risk splitting the stile before the screw is fully seated. The fine thread here bites without forcing the fibers apart. The washer head completes the picture by distributing clamping load across the pocket wall rather than concentrating it at a single point, so the joint pulls together cleanly. The Type 17 auger point adds a fluted cutting edge that clears chips ahead of the thread, lowering the torque needed to drive in dense material and keeping the tip from wandering before thread engagement begins.
This size and thread combination suits cabinet shops that build face-frame cabinets in hardwood as a standard practice. A homeowner tackling a built-in bookcase or mudroom locker in red oak will reach for the same screw. Designers specifying millwork with solid-wood face frames, and contractors installing pre-built hardwood-faced cabinet runs, will find the 1-1/4 inch length covers the joints they encounter most often in 3/4-inch material. For shops running primarily softwood, plywood, or MDF face frames, a coarse-thread version in this family is the better match.
Fine thread is the correct choice for hardwood face frames. Coarse threads apply a wedging force in dense, tight-grained species like maple and oak, which can split the stock before the head seats. Fine thread engages the material without forcing the wood fibers apart.
The screw is designed for angled pocket bores, which are most often cut with a pocket-hole jig. The pocket can be cut by other means, but a jig is the most consistent way to produce the correct bore angle and depth for this head and length combination.
No. The washer head is designed to bear flat against the pocket wall. It does not countersink and should not be driven below the surface. This is the correct behavior for a pocket-hole joint, where the head stays hidden inside the angled pocket.
It will work, but the coarse-thread version in this family is a better fit for softwood, plywood, MDF, and particleboard. Fine thread is optimized for hardwood and delivers its advantage in dense material; coarse thread pulls more aggressively in lower-density stock.
A #2 square drive bit. The square recess holds the bit in the head during driving, which helps with placement and control in tight pocket locations.
For hardwood face-frame joinery in 3/4-inch stock, the 1-1/4 inch SML-F125 brings together the thread, head, point, and drive that the joint actually needs, so rails and stiles pull flush the first time and hold.
Sold In: 1 Box