Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Schwinn part is the left-hand end cap for the 6K376 L-channel handleless profile system, finished in Anodized Nickel. It closes the left-hand cut end of a profile run so the open channel section is not exposed at the termination point.
L-channel profiles come in long lengths and are cut to the width of each cabinet run on site. Every cut end leaves the profile's hollow cross-section open and visible. Left uncapped, that opening reads as unfinished work and becomes a place where dust and debris collect. This cap seats into the left end of a 6K376 run and gives it a clean termination that reads as part of the design rather than as a cut edge.
The cap body is plastic. The Anodized Nickel finish gives the exposed face a cool, silvery tone that sits in the same family as brushed and satin metal surfaces without being an exact match to any one of them. One Schwinn product in the Silver finish carries a stated match to Clear Anodized profiles; Anodized Nickel is a separate finish, and no cross-finish match is stated in the source data for this part. Order sample pieces or confirm against the profile finish before committing to a full run.
This cap suits a kitchen or built-in cabinet project running Schwinn 6K376 L-channel profiles in Anodized Nickel, where the run terminates on the left. It is also the part to specify when a run begins at an open end on the left side, such as at the edge of an island or at the end of a wall cabinet run with no adjacent panel to conceal the profile end. Designers and cabinet shops laying out a handleless kitchen should count left-hand and right-hand terminations separately, since each takes its own cap.
No. Components in this system are dimensioned to a specific profile family. A cap sized for 6K376 will not seat correctly in a different series. Check the series number on your profiles before ordering.
No. This is the left-hand cap. The right-hand cap is a separate item and is not included here.
The listing does not state included fasteners or clips. Confirm what your installation requires when planning the order.
No. L-channel and C-channel profiles have different cross-sections, and their caps are not interchangeable.
Order this cap for every left-hand open end in a Schwinn 6K376 L-channel installation finished in Anodized Nickel, and pair it with the right-hand cap for runs that terminate on both sides.