Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Schwinn component is a rectangular left-hand end cap for the 6K377 L-channel profile handle system, finished in Black. It closes the left cut end of a 6K377 profile run so the open channel cross-section is not exposed in a finished installation.
A handleless L-channel profile is cut to the width of each cabinet run on site, which leaves an open channel section exposed at every cut end. In a cabinet with Black hardware, that exposed end reads as an unfinished detail in an otherwise clean line. This rectangular left-hand cap seats over the left end of a 6K377 profile and closes it flush, carrying the Black finish across the full run from left termination to right. Black is a strong finish choice for modern flatfront and slab-door kitchens where hardware visibility is intentionally low, and a cap in a mismatched finish or left-hand condition would break that continuity.
The cap is plastic, finished in Black. Black as a finish in the Schwinn range reads as a solid, low-sheen dark tone consistent with the profile's own Black anodized or coated surface. Whether the plastic finish reads as a continuous match to the aluminum profile's surface is not stated in the source data, so confirm that detail against your profile specification before finalizing the order. The cap's 1/16 inch projection is minimal, keeping the cap face close to flush with the profile end rather than standing proud of it.
This cap suits a cabinetmaker, installer, or kitchen fitter running Schwinn 6K377 L-channel profiles in Black who needs to finish the left end of a run. It is the right part for a wall of cabinets that terminates at the left against a wall, a tall cabinet end, or any condition where the left profile end will be visible. If the run also has a right-side termination, the matching right-hand rectangular cap is a separate order. Black works especially well in projects where the hardware palette is committed to dark tones throughout, pulling the handleless grip into the same visual register as black-finished hinges, drawer slides, and interior fittings.
No. It is made for the 6K377 series. Other Schwinn L-channel series use their own caps, and the dimensions and cross-sections are not interchangeable.
No. This is the left-hand cap. A right-hand rectangular cap for the 6K377 is a separate item.
The product listing does not state that fasteners or clips are included. Confirm what your installation requires before ordering.
No. L-channel and C-channel components are not interchangeable. This cap is for L-channel profiles in the 6K377 family only.
Order this cap to close the left cut end of a 6K377 L-channel run and carry the Black finish through to a finished edge.