Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Schwinn component is an inner corner for the 6K399 C-channel handleless profile system, finished in Anodized Nickel. It closes a concave corner in a C-channel run so the transition reads as a continuous, finished element rather than two profile lengths meeting at a raw edge.
A handleless C-channel profile is cut to length for each cabinet run, and every cut leaves an open cross-section exposed. Where two runs meet at an inside corner, those open ends need to be closed and the transition needs to be defined so the grip channel reads as intentional, not as two lengths of extrusion that happen to touch. This inner corner piece does that work at the concave angle. It is a finishing component, not a structural one, and it belongs at inside corners only. Outside corners take a separate outer corner part, which carries a different series number.
The Anodized Nickel finish gives this component a clean, cool-toned metallic look that suits contemporary and transitional kitchen designs where the hardware runs silver or satin. The body is plastic, which keeps the piece light and means it will not corrode in a kitchen environment. At 7/8 inch wide with a 1/16 inch projection, it sits close to the cabinet face without adding visible bulk to the corner. Note that this finish is specific to the Schwinn 6K399 system, and a finish match to profiles from another supplier or another series cannot be assumed.
This component is the right choice for a cabinet shop or installer running Schwinn 6K399 C-channel profiles in Anodized Nickel who needs to turn an inside corner cleanly. It fits kitchen renovations and built-in cabinet projects where the handleless grip line continues around an interior corner, such as a peninsula return, an alcove surround, or a U-shaped layout with an inside corner on both walls. Count inside and outside corners separately when ordering, since they are not the same part. If the profiles in the run are from a different Schwinn series, or from Rinco-Matic's SYMA range, this corner is not the right fit.
No. The outer corner is a separate item with a different series number. This part is for inside corners only, where two runs meet at a concave angle.
No. This corner is dimensioned for the Schwinn 6K399 C-channel profile family. Components in this system are specific to their series and do not interchange across suppliers or across series within one supplier.
No. L-channel and C-channel components are not interchangeable, even within the Schwinn range.
The product listing does not state that fasteners or clips are included. Confirm what your installation requires before ordering.
For a 6K399 C-channel run in Anodized Nickel, this inner corner keeps the handleless grip line continuous and clean wherever the layout turns inward.