Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schwinn 2334 Series pull is a contemporary bar pull that mounts on 7-9/16 inch (192 mm) centers, a spacing sized for wide drawer banks, oversized drawer fronts, and tall pantry or appliance-adjacent cabinet doors. It is finished in Satin Nickel and built from zamak alloy.
At 7-9/16 inches between mounting holes, this pull is built for the fronts in a kitchen or bath where a shorter pull would look undersized. Wide drawer bases, pot drawers, and large blind-corner pulls all benefit from hardware that spans enough of the front to feel intentional. The same spacing works on full-height pantry doors and on the tall cabinet fronts flanking a refrigerator, where a 3 or 5 inch pull disappears against the scale of the door. Replacing existing hardware drilled to 192 mm centers is equally straightforward: the hole pattern is already there and this pull drops straight onto it.
The pull is cast in zamak, a zinc-aluminum alloy that holds detail and takes a finish consistently across a production run. The Satin Nickel finish is a brushed, low-sheen silver surface that holds its tone under kitchen and bath lighting without the glare of a polished finish. It stays neutral against white, gray, and wood-toned cabinetry, and it coordinates easily with stainless appliances and brushed nickel fixtures already in the room. The slim 3/8 inch bar cross-section keeps the pull looking light even at this length, so it reads as a horizontal line rather than a heavy fixture on the door face.
Cabinet shops running a contemporary kitchen with wide drawer banks will find the 192 mm spacing covers the most common larger-format hole pattern in that layout. Designers specifying a full kitchen program can pair this pull on drawers with a companion knob from the 2334 Series on door fronts, keeping the finish and design language consistent across the run. Homeowners replacing hardware on an existing wide-drawer cabinet drilled to this spacing get a clean swap with no new drilling. The Satin Nickel finish is a safe specification for any project already running brushed nickel or stainless as the primary metal in the space.
The 192 mm (7-9/16 in) figure is the distance between the centers of the two mounting holes and is the dimension you match to your existing holes or lay out for new drilling. The overall length of the pull is 7-15/16 in (202 mm), which is longer than the hole spacing by roughly 3/8 inch at each end.
Satin Nickel is a brushed silver-tone finish that reads close to brushed stainless in most kitchen settings. Exact match between two manufacturers' finishes is never guaranteed, but the two tend to read as a cohesive metal family rather than a clash.
Yes. The 192 mm spacing and 7-15/16 inch overall length are proportioned for large fronts, including tall pantry and cabinet doors where a shorter pull would look out of scale.
The 2334 is a Schwinn Hardware collection, and companion pieces in the same series share the design language and finish. Check the 2334 Series listings for the knob and other center-to-center options that coordinate with this pull.
When the drawer or door demands a pull with real span, the 2334 Series at 192 mm centers delivers a proportional, low-profile bar in Satin Nickel that works across contemporary kitchens, baths, and built-ins without calling attention to itself.