Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schwinn 2548 Series pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers in a Dark Nickel finish.
The 5-1/16 inch center-to-center is the standard hole pattern on a large share of production cabinet doors and drawer fronts, which makes this pull a straightforward match when replacing existing hardware drilled to that spacing. There is no redrilling, no filling old holes, and no template needed. At 6-1/4 inches overall, the pull has enough visual length to read clearly on a mid-width drawer or an upper cabinet door without overwhelming a narrower front. It is the pull size that disappears into a kitchen in the best sense: it fits the proportions without calling attention to itself.
The pull is cast in zamak, a zinc-aluminum die-casting alloy, and finished in Dark Nickel. Dark Nickel sits in the Silver Tone family but reads warmer and less reflective than a polished or brushed nickel finish. The surface has depth to it rather than a flat grey tone, which means it holds its character under different lighting conditions and shows marks less readily than a bright polish. It coordinates naturally with brushed or gunmetal fixtures without competing with them, and it reads as a neutral against both light and dark cabinetry.
This is a practical choice for a kitchen or bath renovation where the existing hole pattern is 128 mm and the finish program calls for something cooler than bronze or warmer than polished chrome. Cabinet shops and contractors running production installations will find the 128 mm spacing aligns with the most common drilling jigs in use. Designers specifying a contemporary kitchen with mixed metals or matte fixtures can use the Dark Nickel finish as a bridge between cooler silvers and darker accents. Homeowners replacing a full set of pulls on a standard kitchen can match their existing holes without modification.
Measure between the centers of your two existing mounting holes. If that distance is 5-1/16 inches (128 mm), this pull drops straight on.
No. Dark Nickel is a distinct finish with a deeper, warmer tone than standard brushed nickel. The two look different side by side.
Zamak is a zinc-aluminum die-casting alloy commonly used in decorative hardware. It holds finish detail well and is the standard base material for pulls in this category.
Yes. At 6-1/4 inches overall it is proportioned for both drawer fronts and upper cabinet doors drilled to the 128 mm pattern.
For a cabinet program already drilled to 128 mm centers, this pull removes the guesswork and the rework from hardware selection.