Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Schwinn 2930 Series pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 6-5/16 inch (160 mm) centers and measuring 7-9/16 inches overall in a Satin Nickel finish.
The 6-5/16 inch (160 mm) center-to-center is the standard hole pattern for a mid-length bar pull, and it appears on a wide range of base and wall cabinet drawers. At this spacing the pull has enough visual presence to anchor a wide drawer front without overwhelming a standard door. It is especially practical on a kitchen or bath refit: if the existing holes are already drilled to 160 mm centers, this pull drops straight onto them with no new drilling. For a new installation, the 160 mm pattern is common enough in European-standard cabinetry that laying it out once sets the template for the entire run.
The pull is cast in zamak, a zinc-aluminum alloy that takes a consistent plated finish and holds detail well in the bar form. The Satin Nickel finish is a brushed, low-reflectance surface in the silver tone family. It does not pick up highlights under kitchen lighting the way a polished chrome or polished nickel would, which keeps the hardware from becoming a focal point when the cabinetry is meant to carry the room. Satin Nickel also sits comfortably alongside stainless appliances and brushed fixtures, since the tone and sheen level are close enough to read as a coordinated palette rather than a mismatch.
This pull fits a contemporary or transitional kitchen, bathroom vanity, or built-in where the hardware program runs silver-tone and the drawer fronts are wide enough to warrant a mid-length pull. Cabinet shops and contractors who spec the same pull across a full kitchen run benefit from the consistent hole pattern: 160 mm centers are repeatable on a CNC or a jig without case-by-case adjustment. Designers working on a renovation where existing hole spacing must be matched will find the 6-5/16 inch spacing among the more common patterns already in the field. The 2930 Series includes companion pieces, so mixing knobs on doors with pulls on drawers within the same collection is straightforward.
Yes. 6-5/16 inches and 160 mm refer to the same center-to-center spacing. The two units are equivalent and both describe the distance between the centers of the two mounting holes.
Zamak is a zinc-aluminum die-casting alloy. It is the base material most commonly used in cabinet pulls at this price point, finished with a plated surface coat. Solid brass is a different base material and is not what this pull is made from.
Satin Nickel and polished chrome are both silver-tone finishes, but they differ in sheen level. Whether they read as coordinated depends on how close together they appear. Mixing them in the same room is common in practice, though finish matching across brands is never guaranteed.
The source data does not confirm whether screws are included with this pull. Check the product listing or contact us before ordering if fasteners are part of your requirement.
Choose this pull when the job calls for a 6-5/16 inch (160 mm) center-to-center spacing in Satin Nickel, and the hardware should hold a clean, low-sheen line across every front in the room.