Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schwinn 2930 Series pull is a long-run bar pull designed for cabinet doors and drawer fronts that call for hardware at a 12-5/8 inch (320 mm) center-to-center spacing. At this scale it suits the wide base drawers, pantry fronts, and appliance-scale cabinetry where a shorter pull would look proportionally thin.
Most pulls in a kitchen run on 96 mm or 128 mm centers, which suits standard door stiles and mid-width drawer banks. A 320 mm center-to-center is a different conversation entirely. It belongs on a wide pot-and-pan drawer that spans the full base cabinet, on a double-wide pantry door, or on a large appliance-adjacent front where the hardware needs to match the scale of the run. At 13-3/4 inches end to end, this pull does not visually disappear on a 24-inch or 30-inch front the way a shorter bar would. It holds the proportion.
The pull is cast in zamak, a zinc-aluminum alloy that takes a consistent finish across the full length of the bar. The Satin Nickel finish is a brushed, low-sheen surface in the silver tone family. On a pull this long, a matte or brushed finish is a practical choice: it does not pick up reflections from overhead lighting the way a polished surface does, so the bar reads as a clean line rather than a strip of glare. Satin Nickel also sits neutrally against stainless appliances, light-colored fronts, and most white or gray painted cabinetry.
This pull works for kitchen designers specifying a consistent pull program across varied drawer widths, cabinet shops equipping a run of base cabinetry with oversized drawers, and homeowners replacing hardware on a wide pull-out or pantry front where the original hole spacing was already at 320 mm. Because this belongs to the 2930 collection, companion pieces in the same series and finish carry the same profile and can be coordinated across narrower drawers and doors in the same installation without mixing design languages.
Center-to-center, 12-5/8 inches (320 mm), is the distance between the two mounting holes and is the drilling dimension. Overall length, 13-3/4 inches (349 mm), is the end-to-end size of the pull. Match your existing holes to the center-to-center figure, not the overall length.
Satin Nickel is a brushed, low-sheen finish. It has a soft sheen rather than a mirror polish, which reduces visible fingerprints and glare on a long horizontal bar.
Yes. At this center-to-center spacing it is equally at home on a wide pantry door or a large drawer front, provided the front is wide enough to accept the full 13-3/4 inch length without overhanging the edges.
The 2930 collection includes pulls at multiple center-to-center spacings in the same bar profile and Satin Nickel finish, so a mixed drawer bank can run a consistent look across different widths.
When the project includes wide base drawers or oversized fronts, this pull delivers the span and the finish to keep the hardware program cohesive without asking the drawer to carry an undersized bar.