Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schwinn Z240 Series pull is a contemporary cabinet pull for doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers — one of the most common hole patterns in production cabinetry.
The 128 mm center-to-center spacing is the standard most production cabinet lines are drilled to, which means this pull drops onto existing holes in a wide range of kitchen, bath, and built-in installations without any re-drilling. It is a practical choice for a replacement run where matching the existing hole pattern is the first constraint, and a sensible default spec for new work where the cabinetry will be drilled to 128 mm centers. At 5-9/16 inches overall, it gives enough visual length to register on a mid-width drawer or door without overwhelming a narrower front.
The pull is cast in zinc alloy and finished in Polished Chrome. Chrome is reflective by nature, and on a thin, flat bar profile like this one the polish runs as a continuous bright line across the front. That reflectivity makes it a natural companion to chrome faucets, appliance trim, and light fixtures already present in most kitchens and baths. The slim 1/2 inch width keeps the bar visually light, so the hardware reads as a detail rather than a feature. Polished surfaces show marks more readily than brushed or matte ones and wipe clean just as easily.
This is a strong choice for a kitchen or bath renovation where chrome is the existing metal in the room and the cabinet hardware needs to join rather than contrast with it. It suits slab-front, shaker, and other flat-front door styles where a thin bar pull follows the geometry of the cabinetry. Cabinet shops speccing hardware for a production run of 128 mm pre-drilled boxes will find the spacing is already dialed in. Designers mixing pulls on drawers with knobs on doors can draw from the Z240 collection to keep both pieces in the same design language.
Yes. The pull mounts on 5-1/16 inch (128 mm) centers, which is the same spacing. Confirm by measuring between the centers of your existing holes before ordering.
The grip is 1/2 inch (12.5 mm) wide, which gives it a slim, linear look against the door face.
The Z240 is a collection, so companion hardware in the same series and finish is available to coordinate doors and drawers.
It is a surface-mounted two-hole pull and works on either. The 5-9/16 inch length suits mid-width drawers and upper cabinet doors particularly well.
When the hole pattern is already at 128 mm and the room is running chrome, this pull removes the guesswork and keeps the hardware program consistent across every front.