Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schwinn Z240 pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers — one of the most widely drilled spacings in residential cabinetry.
The 5-1/16 inch (128 mm) center-to-center spacing is the go-to measurement for a wide range of upper doors and mid-width drawer fronts. On an existing cabinet run that was drilled to this spacing, this pull drops onto the holes without a template or a new boring pattern. For a fresh installation, the same spacing keeps the hardware in step with virtually every off-the-shelf hinge boring and accessory that references it. If the current job involves a bank of drawers in the 12 to 18 inch range, this is the center-to-center that reads as anchored rather than undersized.
The Z240 is cast in zamak, a zinc-aluminum alloy that holds a machined edge cleanly and takes a plated finish without the porosity issues of softer castings. The Satin Nickel surface is brushed rather than polished, which gives it a soft, even sheen that diffuses kitchen light instead of reflecting it as a bright line. That quality makes satin nickel a practical choice in rooms where polished chrome would pick up every light source and grease mark. It also coordinates naturally with brushed stainless appliances, satin nickel faucets, and the broad range of silver-tone fixtures already common in contemporary kitchens and baths.
This pull suits cabinet shops and contractors specifying hardware for contemporary kitchens, bathrooms, and laundry rooms where a clean bar profile is the expected look. At 5-9/16 inches overall it handles upper door fronts and drawer faces in the mid-width range without competing visually with the cabinetry. Homeowners replacing worn or mismatched hardware on a drilled-to-128mm cabinet run will find this a straightforward fit. Designers assembling a full hardware program can extend the same profile into other centers within the Z240 series, keeping the design language consistent across a mixed kitchen layout.
Yes. The two values are the paired imperial and metric expression of one standard spacing. Both refer to the same drilling dimension.
The grip is 1/2 inch (12.5 mm) wide and flat-profiled, so it sits close to the door face and reads as a line rather than a round bar.
In most kitchens, yes. Both are brushed silver-tone finishes, and the two read as a matched set at cabinet distance. Satin Nickel is a plated finish, and the exact tone varies by manufacturer, so viewing them together in the space before committing the full run is sound practice.
The Z240 series is offered in multiple center-to-center sizes. Check the other variants in this series to find the spacing that matches your layout.
When the hole pattern is already drilled and the finish needs to work alongside brushed fixtures, the Z240 in Satin Nickel covers both without a compromise.