Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schwinn 4145 Series pull is a knurled stainless steel bar pull for cabinet doors and wide drawer fronts, mounting on 7-9/16 inch (192 mm) centers.
The 7-9/16 inch hole spacing puts this pull in the category used for wide base drawers, spice-rack pulls, full-height pantry doors, and appliance-scale fronts. At that span the grip sits at roughly a third of the front's width on a 24-inch drawer, which is where hardware proportion tends to feel balanced rather than pinched or oversized. A shorter pull centered on the same front would leave a lot of door around it; this one fills the space with intention. The 8-7/16 inch overall length tracks close to the centers, keeping the overhang tight and the silhouette clean rather than sweeping past the holes.
Knurling is a machined crosshatch cut into the barrel that serves two purposes: it gives fingers something to hold against the pull under a wet or oily hand, and it scatters light instead of reflecting it in a single bright line. A polished bar reads as a highlight across the front; a knurled bar sits more quietly in the room while still reading as metal. The stainless construction carries the silver tone without the warm bias of a brushed nickel or the cool blue cast of a chrome, and it does so without the periodic re-polishing that plated finishes eventually require.
This is the pull for a kitchen where wide drawers are doing real work: deep pots-and-pans drawers, full-extension base drawers, or a bank of large drawer faces on an island. The contemporary line of the 4145 Series places it naturally in flat-front, slab-door, and frameless cabinetry where the hardware is expected to be geometric and unadorned. It also suits a commercial-kitchen aesthetic in a residential space, where the stainless finish connects cabinet hardware to the appliances and countertops already running in the same metal family. Designers specifying a full kitchen run can pair this spacing with a shorter pull from the same 4145 Series on narrower drawers and doors to keep a consistent design language across the wall.
The mounting holes are drilled on 7-9/16 inch (192 mm) centers, which is the distance between the centers of the two holes, not the overall length of the pull.
Yes. The crosshatch pattern cut into the barrel creates a non-slip grip surface that is noticeably more secure than a smooth bar, especially with wet hands.
The 192 mm spacing works well on tall pantry and full-height cabinet doors, not only on wide drawers. The scale reads proportionally on any large front.
Yes. The 4145 Series includes companion pieces in the same design language, so you can use a different center-to-center spacing from the same series on narrower fronts.
When the drawer is wide enough to earn a pull with real reach, this knurled stainless bar delivers the spacing, the grip, and the contemporary line to match it.