Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Schwinn 2891 Series pull is a contemporary rectangular cabinet pull sized for wide drawer fronts and full-height door panels, mounting on 7-9/16 inch (192 mm) centers.
A 7-9/16 inch center-to-center is a deliberate choice for specific fronts. It suits the wide base drawers on a kitchen island, deep pot-and-pan drawers, and full-height pantry doors where a shorter pull would look proportionally light. At this spacing the hardware registers as a horizontal element across the front rather than a small accent at the center of it. The 7-15/16 inch overall length keeps the ends tight to the posts, so the pull reads as a clean bar rather than one with exposed overhang at each side.
The pull is cast in zamak, a zinc-aluminum alloy that holds precise detail through the die-casting process. The Matte Black finish is applied with a low-sheen surface that absorbs light rather than reflecting it, which keeps the hardware consistent across varied kitchen lighting. On a wide front, a matte finish prevents the pull from becoming a focal point at every angle, which is especially useful when the cabinetry itself is meant to carry the room. The rectangular cross-section has flat faces on all sides, reinforcing the straight-line geometry that contemporary door and drawer programs are built around.
This is the right choice when the project already uses a black hardware program and the widest fronts in the run need to stay in the same family. It works equally well in a kitchen remodel where wide drawers are being re-drilled to a new layout, and in new construction where the cabinetmaker is specifying a single pull series across varied front widths. Because the 2891 Series includes other center-to-center sizes, a shop can run pulls across the full range of drawer and door widths without mixing collections or finish batches.
Yes. The 192 mm center-to-center is one of the standard wide-pull spacings used across contemporary cabinet programs, and many door and drawer fronts are pre-drilled or templated to this dimension.
The projection is 13/16 inch (21 mm), measured from the door face to the back of the grip.
The 2891 Series includes multiple center-to-center sizes, so companion pulls in the same design and finish are available for smaller fronts in the same run.
The overall length is 7-15/16 inches against a 7-9/16 inch center-to-center, leaving just under 3/16 inch beyond each mounting post. The bar ends close to the posts with minimal exposed length.
When the pull program needs to hold a straight matte-black line across a wide drawer or pantry door without drawing attention to itself, this is the size that does it.