Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Schwinn Z273 pull is a contemporary bar pull for cabinet doors and drawer fronts, finished in Matte Black.
The 6-5/16 inch center-to-center spacing steps up from the 3-3/4 inch and 5-1/16 inch pulls that dominate narrower drawers and upper doors. That makes this a natural fit for wide base drawers, pantry doors, and full-height cabinet fronts where a shorter pull would look undersized against the door. At 6-7/8 inches end to end, there is enough length to read clearly across a wider front without overwhelming it. The slim 1/4 inch bar keeps the profile from competing with the cabinetry, which suits slab and shaker doors where the hardware should register as a line rather than a mass.
The pull is cast in zamak, a zinc-aluminum alloy that takes a machined finish cleanly and holds its form under daily use. The Matte Black surface has no polish to it: light falls across the bar without bouncing back, which means the pull holds its color consistently from different angles and under different light sources. That evenness is part of why matte black reads as intentional contrast against light-colored fronts and as a quiet detail against dark ones. It also handles smudges differently than a polished finish does, with marks less visible between cleanings on a surface that does not magnify them.
This pull suits a contemporary kitchen, bath, or utility space where the hardware program is black and the cabinetry is flat-fronted. It is a practical choice for a cabinet shop specifying a full kitchen run, because the 160 mm spacing covers the drawer and door sizes that call for a longer pull without requiring a separate sizing decision. Designers assembling a mixed hardware set can pair it with smaller pulls or knobs from the Z273 series to maintain a consistent design language across narrow and wide fronts in the same installation.
Measure between the centers of your existing mounting holes. If they land at 6-5/16 inches (160 mm), this pull drops in without any new drilling. If you are installing fresh, mark the hole centers at 160 mm apart on the front.
The grip is a bar at 1/4 inch wide. It is a slim, linear section rather than a thick cylindrical bar, which keeps the profile low against the door face.
A matte finish is more forgiving than a polished one. Oils and marks are less visible because the surface does not reflect light to highlight them.
Yes. The 6-5/16 inch center-to-center is a spacing commonly used on pantry doors and taller cabinet fronts where a shorter pull would look out of proportion.
Choose this pull when the hardware should hold a flat, consistent matte black line across wider fronts without drawing attention away from the cabinetry itself.