Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Schwinn 3766 Series tab pull is a contemporary aluminum pull for cabinet doors and drawer fronts, mounting on 6-5/16 inch (160 mm) centers.
A 6-5/16 inch center-to-center is one of the standard wider pull spacings, and it is the right fit for base cabinet drawer banks, two-door wall sections, and pantry fronts where a narrower pull would read as undersized against the face. At this spacing, the pull has enough visual weight to anchor a wide front without competing with the cabinetry itself. It is also the correct replacement spacing for any existing hardware drilled to 160 mm centers, which is a common hole pattern in mid-scale contemporary cabinetry.
The pull is made from aluminum, which keeps it lighter than a comparable zinc or steel bar pull at the same length. The Anodized Nickel finish is an electrochemical surface treatment applied directly into the aluminum, not a plated coating sitting on top of it. The result is a cool silver tone that resists wear at the points of daily contact, the grip and the base, where a painted or lacquered finish would show the most use first. Against white, gray, or natural wood fronts it reads as a clean neutral.
This pull is a practical choice for a contemporary kitchen, bath, or built-in where the hardware program is silver-toned and the cabinetry is flat-fronted or lightly profiled. The tab form, flat and simple at its widest face, suits a slab or shaker door without adding visual noise. Cabinet shops fitting out a run of base drawers at 160 mm centers, homeowners replacing worn hardware without re-drilling, and designers building a consistent silver-toned program across a full kitchen will each find the 3766 Series a straightforward match. Because it belongs to the Schwinn 3766 collection, companion pieces in the same series are available for coordinating the rest of the run.
Center-to-center, 6-5/16 inches (160 mm), is the distance between the two mounting holes and the number to match against your existing holes or drilling template. The overall length, 11-13/16 inches (300 mm), is the full end-to-end size of the pull and is larger than the hole spacing.
No. Anodizing converts the surface of the aluminum itself into a durable oxide layer. Plating deposits a separate metal coating on top of the base material. Anodizing is integral to the aluminum and does not peel or flake the way a plated finish can.
Yes. Tab pulls are surface-mounted through two holes and suit both cabinet doors and drawer fronts at this center-to-center spacing.
The Schwinn 3766 Series includes companion pieces in the same design language and finish, so you can coordinate pulls across different center-to-center sizes within the collection.
Choose this pull when the project calls for a 160 mm hole pattern, an aluminum build, and a low-sheen nickel finish that holds its look at a busy drawer bank.