Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Schwinn 3766 Series tab pull is an anodized aluminum cabinet pull sized for wide drawer fronts and tall door applications where a standard bar pull would look undersized.
Wide drawer fronts on base cabinets, deep pot drawers, and large pantry pull-outs are where this pull makes the most sense. A 15-1/8 inch center-to-center spacing gives a wide front hardware that is proportional to it rather than hardware that looks borrowed from a narrower drawer. The tab form keeps the profile low and linear, which suits slab-front and flat-panel cabinetry where the geometry is already spare. It also works well on tall upper doors in kitchens with elevated ceilings, where hardware scaled to the door reads better than a shorter pull that gets lost on a large face.
Aluminum is the base material here, and anodizing is an electrochemical process that converts the surface layer of the metal itself into a hard oxide coating rather than applying a film over it. The result is a finish that cannot chip, flake, or delaminate the way a painted or plated surface can. The Anodized Aluminum finish reads as a neutral silver tone under most kitchen and bath lighting conditions. It coordinates naturally with stainless appliance fronts and brushed metal fixtures without promising an exact match, since anodized aluminum and brushed stainless are different surfaces with different light behavior.
Cabinet shops finishing contemporary kitchens with wide base drawers reach for a pull at this center-to-center when the design calls for hardware that holds proportion across the front. Designers working on minimalist or Scandinavian-leaning interiors appreciate the tab form because it avoids the round-bar look that reads as a different vocabulary from flat-front doors. Contractors on spec builds and multifamily projects find the anodized aluminum practical: the finish holds up through installation handling and does not need babying the way a polished surface does. The 3766 Series carries companion pieces in the same profile family for projects that need consistent hardware across multiple sizes.
A bar pull has a cylindrical or rounded grip carried on two posts. A tab pull uses a flat, plate-like form that mounts flush or near-flush to the door face, giving a lower profile and a more rectilinear silhouette.
No. Anodized aluminum is the metal's own surface converted by an electrochemical process, while chrome and polished nickel are plated over a base metal. They share a silver tone family but have different surface texture, sheen level, and light behavior.
It mounts on 15-1/8 in (384 mm) centers, so it will align with holes drilled to that spacing. Measure between the centers of your existing holes to confirm before ordering.
Yes. The Schwinn 3766 Series is available at multiple center-to-center spacings, so you can run different lengths across narrow and wide fronts while staying in the same profile family.
This pull is the right choice when the drawer or door is wide enough that smaller hardware looks like an afterthought, and the project calls for an anodized aluminum surface that will still look right years down the road.