Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Schwinn 3766 Series tab pull is a long-span contemporary pull designed for wide drawer banks, oversized door fronts, and appliance-scale cabinetry that demands hardware sized to match.
A center-to-center of 15-1/8 inches is sized for fronts that smaller pulls leave visually underscaled. Wide base drawers, full-height pantry doors, island drawer banks, and entertainment cabinet fronts all benefit from hardware at this span. The tab profile sits low on the front and runs parallel to the grain of the cabinetry, so the 20-plus inch overall length reads as a horizontal element rather than a protruding grip. On a wide shaker or slab front, that horizontal line reinforces the geometry of the door instead of interrupting it.
The pull is extruded aluminum finished in Anodized Nickel. Anodizing is an electrochemical process that hardens the surface of the aluminum itself rather than coating it, so the finish does not chip or peel away from an underlying substrate the way plating can. Anodized Nickel reads as a cool, medium-bright silver with a consistent tone across the pull's length, which matters on a 20-inch piece where any variation in finish would be visible. Aluminum construction keeps the pull light relative to its size, a practical consideration when hardware at this span is handled repeatedly across a full drawer bank.
Designers specifying contemporary kitchens often use long pulls to anchor wide islands and pantry columns where a standard 5-inch pull would read as an accent rather than as a hardware program. Cabinet shops building entertainment units, home office banks, and media consoles reach for this length when the drawer fronts run 24 inches or wider. Contractors finishing high-end residential kitchens find that a consistent 384 mm pull across the base cabinetry gives the run a unified, furniture-like appearance. The 3766 Series covers multiple center-to-center sizes within the same design language, so a single project can be detailed from the narrowest door to the widest drawer in one collection.
Anodized aluminum is cleaned with mild soap and water. Avoid abrasive cleaners, which can dull the surface over time.
A tab pull is typically a flat, plate-like profile gripped at its face or edge rather than a round or squared bar on posts. The result is a lower-profile pull that sits closer to the door front.
At 15-1/8 inches center-to-center and nearly 21 inches overall, this pull works well on fronts in the 30-to-36-inch range. Sizing hardware to roughly a third of the front's width is a common design practice, though it is a preference rather than a requirement.
Yes. The Schwinn 3766 Series is available in multiple center-to-center sizes within the same design language and Anodized Nickel finish.
When the cabinetry runs wide, the hardware should too. This pull brings consistent scale and a durable anodized surface to the largest fronts in a contemporary kitchen or built-in program.