Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune ES-Z009 is a transitional bar pull for cabinet doors and drawer fronts, finished in Dark Bronze and built to the 3-3/4 inch (96 mm) center-to-center spacing that fits the most common cabinet hole pattern in residential and commercial kitchens.
Dark Bronze hardware earns its place in kitchens and baths where the goal is warmth and grounding rather than brightness. Against painted white or cream cabinetry it reads as a strong, intentional contrast. Against stained wood it deepens the tone of the room without competing with the grain. On gray or greige fronts it pulls the palette toward warm rather than cool, which is a common design move in transitional interiors that want to avoid the cold edge that matte black can sometimes introduce.
At 5-1/4 inches overall, this pull suits a mid-width drawer or an upper cabinet door. It is also a practical choice for a full kitchen refresh where the existing hole pattern is already drilled to 96 mm, because no new drilling is needed on any front that matches that spacing.
The pull is cast in zinc and finished in Dark Bronze. The Dark Bronze finish sits in the bronze-tone family but carries more depth and less yellow than an antique brass or antique copper finish would. It is not a polished surface: the tone is even and low-sheen, which means it does not pick up hot spots under kitchen lighting the way a lacquered or polished finish does. Sugatsune is precise about its finish names, and Dark Bronze is a distinct catalog value, not a generic color description.
Zinc is the dominant construction material in this segment, and it suits the application well: it holds finish consistently across production runs, which matters when you are ordering pulls across a full kitchen and need them to match.
Designers working on transitional kitchens and baths reach for this pull when the hardware program needs warmth without the brightness of brass and without the starkness of matte black. Cabinet shops doing a full install appreciate that the 96 mm center-to-center is already the drilled standard on most frameless and face-frame boxes, so it drops onto existing hardware without any modification to the door or drawer. Contractors refreshing a kitchen for resale find that dark bronze ages well in a room and photographs with depth rather than glare.
No. Dark Bronze is Sugatsune's own finish name and describes a specific, even dark tone. Oil-rubbed bronze is a different finish treatment, typically applied with a two-tone or highlighted effect, and is not the same finish as this one.
Yes. The mounting centers on this pull are 3-3/4 inches (96 mm), which is the standard 96 mm hole pattern used on most residential cabinetry. Measure between the centers of your existing holes to confirm before ordering.
Yes. The ES-Z009 is a series, and companion pieces in the same design line are available. Coordination within the series gives you a consistent profile and finish across different pull sizes and configurations.
The Dark Bronze finish is an indoor hardware finish. It is not rated for exterior or wet-area applications. For standard kitchen and bath cabinetry in a dry indoor environment, zinc with a factory-applied finish is the standard construction for this category.
Choose this pull when the cabinetry calls for a warm, grounded finish that holds its presence without glare, and when the hole pattern is already at 96 mm.