Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune J95 Series hinge mounts inset doors flush inside the cabinet opening on both face-frame and frameless cabinets, with a self-close spring and a Black Nickel finish built for visible hardware applications.
An inset door fits inside the cabinet box rather than over it, framed by a consistent reveal on every edge. That reveal is the measure of the job, and this hinge carries the inset geometry that lets the door swing clear of the opening without binding. The 40mm cup bores into the door face, and the arm mounts directly to the cabinet side or stile with screws, no separate base plate required. The 48mm boring pattern is specific to the J95 series, so confirm your layout before boring new holes or matching an existing pattern. At 93 degrees of opening, the door clears the cabinet front cleanly, which is the engineered swing for a door that sits flush at rest rather than proud of the face.
The hinge is steel in a Black Nickel finish. Black Nickel sits between matte black and brushed nickel: it reads dark with a subdued metallic quality that holds up against visible cabinetry and coordinates naturally with darker pulls and hardware. Inset cabinetry is often where the hinge is seen, because the cup and arm are visible inside the opening when the door is open. A finish-matched hinge keeps that interior consistent. The screw-on connection gives a firm, non-flex mount that holds an inset door in position over time, which matters when the reveal is what the eye measures.
This is the hinge for designers and cabinet shops specifying inset doors in a Black Nickel finish palette. It works on face-frame and frameless cabinets alike, and the 55 lb per-pair weight rating covers solid wood doors in the standard inset thickness range up to 1-3/16 inches. For thick-panel or slab doors approaching that upper edge, confirm the door weight against the load guidance before setting the hinge count. Contractors finishing a run of furniture-grade cabinetry or built-ins where hardware finish runs through the whole piece will find this hinge integrates cleanly into the visible spec. If the project calls for a damped, cushioned close rather than a spring pull, this is not that hinge. The self-close spring closes the door; it does not slow it at contact.
No. The J95 screw-on arm mounts directly to the cabinet side or stile with screws, so no separate base plate is needed for this installation.
Self-close uses a spring to pull the door shut over the last few degrees. Soft-close uses a damper to slow and cushion the door before it contacts the frame. This hinge is self-close: the spring pulls the door shut but does not slow the final contact.
No. The J95 uses a 48mm boring pattern, not the more common 45mm. If you are replacing existing hinges or boring into pre-drilled doors, confirm the spacing matches before ordering.
Yes. The J95 screw-on mount works on both face-frame and frameless boxes. On frameless cabinets, the arm screws to the side panel.
Specify this hinge when the design calls for inset doors that sit square in the opening, close on their own, and carry a Black Nickel finish through the full hardware run.
Sold In: 1 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  SLJ95-P6T-BN Mfr# J95-P6T-BN | Sugatsune J95 Hinge Mounting Plate Black Nickel, - J95-P6T-BN |
