
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
The Quickscrews #8 x 1-1/8 inch Modified Washer Head Drawer Front Adjusting Screw is a dedicated hardware fastener for attaching and aligning drawer fronts on cabinet drawer boxes. The 1-1/8 inch length is sized for thinner drawer fronts and standard drawer box faces where a longer screw would over-penetrate, and the modified washer head spreads clamping load evenly so the front stays put during final adjustment.
Drawer front installation involves driving through the drawer box face into the back of the drawer front, usually through an elongated slot that allows lateral and vertical adjustment before the screw is fully tightened. In that application, the working depth available is determined by the combined thickness of the drawer box face and the drawer front material. A 1-1/8 inch screw is the right call when a 1-1/4 inch screw would punch through the face of the drawer front or leave insufficient thread engagement to hold the panel securely. Cabinet shops building boxes from thinner plywood or melamine panels, and installers working with overlay fronts on shallower drawer boxes, find this length fits the stack without any trimming or shimming.
The modified washer head is wider than a standard pan head, which matters when the screw is passing through an oversized or elongated adjustment slot in the drawer box face. The broader bearing surface bridges the slot opening and keeps the drawer front from rocking or shifting before final tightening. The zinc finish is standard for interior cabinetry: it handles the low-humidity environment inside a cabinet box without contributing rust staining to finished interiors. This screw is intended for indoor cabinet use.
Cabinet shops running production lines, kitchen installers fitting out multiple units, and millwork teams assembling frameless or face-frame cabinets all burn through drawer front adjusting screws quickly. The 6,000-count box keeps a consistent, purpose-built fastener on hand without the interruptions that come from running short mid-job. Because the screw is designed specifically for drawer front attachment rather than adapted from a general-purpose wood screw, the head geometry and length work together for the application rather than requiring workarounds.
The 1-1/8 inch length suits thinner drawer front stock or shallower drawer box configurations where a 1-1/4 inch screw would over-penetrate. If your combined drawer box face and drawer front thickness leaves limited depth, the shorter screw keeps the tip from breaking through the face of the front.
The modified washer head is wider than a standard pan head, so it spans the elongated adjustment slot in the drawer box face more effectively. That wider bearing surface holds the drawer front steady during positioning instead of letting it pivot or shift around the fastener.
Yes. Drawer front adjusting screws are designed to pass through the elongated slots built into drawer box faces or adjustment clips, and this screw's head and shank dimensions are sized for that use. Verify the slot and hole dimensions in your specific hardware match a #8 screw before ordering.
Functionally, yes. Square drive and Robertson refer to the same four-sided recess geometry. A #2 square bit is the correct driver for this screw.
The zinc finish is suited for standard indoor cabinet environments. For installations in areas with persistent moisture or humidity, a more corrosion-resistant finish would be the better choice.
When the drawer front thickness and box depth call for a shorter reach, the Quickscrews #8 x 1-1/8 inch Drawer Front Adjusting Screw gives you the right length, the right head, and the volume to keep a production schedule moving.
Sold In: 6000 Each