Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Additions tab pull is a compact finger-grip pull for cabinet doors and drawer fronts, mounting on 2-1/4 inch (57 mm) centers and finishing 3 inches overall in Brushed Satin Nickel.
The 57 mm center-to-center on this pull fills a specific gap in most hardware programs. It is narrower than the 3-inch spacing common on base drawers and wider than the tightest tab configurations, which makes it the right choice when existing holes fall at that mid-range measurement and replacement hardware needs to drop in without redrilling. It also suits narrow upper-cabinet doors, shallow spice drawers, and tall pantry pulls where a shorter grip reads in proportion with the front. The tab form keeps the mounting compact: the pull lays close to the surface rather than projecting outward, so it does not compete visually with the cabinetry or create a snagging point in a tight run.
The pull is constructed from steel and finished in Brushed Satin Nickel. Steel runs stiffer than the zinc alloy common across much of this segment, which gives the tab a consistent feel at the narrow width this form factor calls for. Brushed Satin Nickel is a medium-silver finish with a fine directional texture that diffuses light rather than reflecting it. It reads neutral in most kitchens and baths, coordinating with stainless appliances, chrome fixtures, and matte silver hardware without requiring a perfect finish match across brands. Marks and light scuffs are less visible on a brushed surface than on a polished one, which matters on hardware that sees daily contact.
This pull fits well in contemporary kitchens and baths where the hardware should register as a detail rather than a statement. Designers working on flat-front slab or shaker cabinetry reach for tab pulls when the goal is a clean face with minimal visual interruption. Contractors on a replacement job with existing 57 mm holes can swap this in without touching the door or drawer front. Cabinet shops building narrow door and drawer units benefit from the proportional fit the 2-1/4 inch spacing delivers on fronts where a longer pull would overhang the edges. Because this pull is part of the Additions collection, companion knobs and pulls in the same series are available for a coordinated hardware program across the whole project.
Drill on 2-1/4 inch (57 mm) centers. The overall length is 3 inches, which is larger than the hole spacing, so match the hole measurement, not the total length of the pull.
It is a mid-sheen brushed finish, neither fully matte nor polished. The fine texture softens the surface without eliminating its silver tone.
Yes. The Additions collection includes companion pieces in matching designs and finishes, which is the straightforward way to run pulls on drawers and knobs on doors from one series.
Tab pulls are used on both doors and drawers. The low-profile form works particularly well on upper cabinet doors and narrow fronts where a longer bar pull would look oversized.
When the project calls for a 57 mm drilling pattern and a brushed silver finish that stays out of the way, this Additions tab pull delivers the fit without requiring a workaround.
Sold In: 1 Each