Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Appliance series pull is a bar pull for cabinet doors and wide drawer fronts, mounting on 7 inch (178 mm) centers in a Brushed Satin Nickel finish.
A 7 inch center-to-center spacing belongs on a different class of front than a standard bar pull. Wide base drawers, deep pot-and-pan drawers, and tall pantry doors are the natural home for a pull at this scale. The hardware should be proportional to the front it sits on, and at 178 mm between holes this pull reads as intentional on a wide front rather than as hardware that got lost on a narrow one.
It also suits furniture-scale cabinetry: islands with wide drawer banks, custom built-ins with full-depth drawers, and vanities with wide apron fronts where a smaller pull would look underscaled. The 1-3/4 inch projection gives a full-hand grip with room for fingers behind the bar, which matters on a heavy drawer loaded with cookware.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface mutes the silver tone and keeps it consistent under different lighting conditions, which is one of the practical reasons satin nickel remains a workhorse finish in kitchen and bath hardware programs. It does not pick up glare the way a polished nickel would, and it coordinates with a wide range of fixture metals already in most kitchens without demanding an exact match.
The 3/4 inch wide bar section gives the grip a solid feel without adding visual bulk. At this spacing and scale, that proportion keeps the pull from looking heavy against the front while still delivering a bar with real presence.
This pull is a practical choice for cabinet shops and designers specifying hardware for kitchens and baths with wide-format cabinetry. At 7 inch centers it fills a spacing that a standard 3-3/4 or 5-1/16 inch pull cannot, and the transitional design language makes it compatible with a broad range of door styles, from flat-panel contemporary to raised-panel traditional. Contractors retrofitting an existing kitchen drilled to 178 mm centers will find it a direct swap. Homeowners building or renovating who want hardware that scales to large drawers and keeps a clean, brushed silver tone will find the same.
Because it belongs to the Top Knobs Appliance series, companion pieces in matching finishes are available in the same collection, making it straightforward to run a consistent hardware program across pulls, knobs, and larger appliance-scale fronts.
Center-to-center, 7 inches (178 mm), is the distance between the two mounting holes and the number to match when replacing existing hardware. Overall length, 7-11/16 inches, is the end-to-end size of the pull and is always slightly larger than the hole spacing.
The projection is 1-3/4 inches (44 mm), measured from the door face to the back of the bar.
No. Brushed Satin Nickel has a muted, low-sheen surface. Polished nickel and chrome are bright and reflective. The brushed finish reduces glare and shows marks less readily than either polished option.
Yes. A bar pull mounts on a door or a drawer front the same way, through two holes at the stated center-to-center spacing.
At 7 inch centers and a 1-3/4 inch projection, this pull is sized for wide, substantial fronts where undersized hardware would look misplaced. Brushed Satin Nickel keeps the finish neutral enough to work across most kitchen and bath programs without a difficult coordination decision.
Sold In: 1 Each