Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Appliance series pull is a bar pull for cabinet doors and drawer fronts that demand hardware at scale, mounting on 7-inch (178 mm) centers.
Seven inches between centers is a significant span, and it earns its place on the widest drawers in a kitchen: a deep pot drawer, a wide base drawer in a furniture-style island, or a tall pantry door where smaller hardware would look undersized. At nearly 10 inches tip to tip, the pull reads as a deliberate design element rather than an afterthought. It is also one of the cleaner ways to handle a 36-inch or wider cabinet front without scaling up to an appliance-length pull: wide enough to feel substantial, compact enough to leave room on either side of the front.
The pull is cast in zinc and finished in Patina Black. Unlike a flat matte black, a patina finish carries subtle depth and tonal variation across the surface, which gives the bar a crafted quality that reads particularly well on painted Shaker or raised-panel fronts. The 7/8-inch bar section is squared rather than round, so the face sits flush to the front's plane and holds the clean horizontal line that transitional cabinetry calls for. The 1-7/8-inch projection keeps fingers well clear of the door face, which matters on a pull this wide where the grip tends to be used with the whole hand.
This pull is a natural choice for a transitional kitchen running a mix of traditional and contemporary elements, where the hardware needs enough visual presence to anchor wide fronts without fighting the overall design. Cabinet shops specifying hardware for painted or stained frameless and face-frame cabinetry will find the 7-inch spacing common on larger drawer banks. Designers mixing knobs on doors with pulls on drawers can pull companion pieces from the Appliance series to keep the collection consistent across the layout. Homeowners replacing existing hardware drilled to 7-inch centers have a direct swap with no new holes required.
The center-to-center measurement, 7 inches (178 mm), is the distance between the two mounting holes. That is the drilling dimension. The overall length, 9-11/16 inches (246 mm), is the full end-to-end size of the bar. Match your existing holes to the center-to-center figure, not the overall length.
No. Patina Black carries more surface depth and tonal variation than a uniform matte black. The two finishes look different in person, especially under kitchen lighting.
Yes. At 7 inches center-to-center it is well proportioned for a wider upper cabinet door, particularly on a 15-inch or 18-inch door where a shorter pull would look undersized.
The Appliance collection from Top Knobs includes companion hardware. Look for matching pieces in the same series and finish to coordinate across doors and drawers.
When the drawer bank is wide and the hardware needs to match that scale, this pull delivers the span, the clearance, and the finish depth to do the job without overreaching the design.
Sold In: 1 Each