Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Asbury pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers.
The 5-1/16 inch (128 mm) center-to-center spacing sits between the common 4 inch and 6-5/16 inch drill patterns, and it is one of the more widely specified hole spacings on mid-range and upper-end cabinetry. That means this pull is often a direct replacement on an existing layout without any new drilling. On a fresh build it suits a drawer front in the 15 to 20 inch range, where a smaller pull starts to look underdressed and a longer one overreaches. It also works well on a single-door upper cabinet, where the pull should stay centered and proportional rather than spanning the whole front.
The Asbury pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface scatters light rather than reflecting it cleanly, which keeps the pull from drawing attention when the cabinetry is the focal point. Satin Nickel sits in the cool-silver family, coordinating naturally with stainless appliances, chrome fixtures, and light-toned hardware elsewhere in the room. The squared 3/8 inch bar section gives the grip a flat face along its length, so the pull reads as a precise geometric element rather than a rounded accent. At 1-1/4 inch projection the grip sits close enough to the door to feel deliberate without pulling the hand back at an awkward angle.
The Asbury collection's transitional design style makes this pull a dependable choice when the cabinet program is neither fully contemporary nor fully traditional. Designers running a mixed kitchen, with shaker uppers and slab drawer fronts, or contractors finishing a spec home that needs hardware to read clean without being stark, consistently land on a brushed nickel bar pull at this scale. It is also a practical pick for a cabinet shop building to a client's existing hole pattern: 128 mm spacing appears often enough in production cabinetry that this pull can ship with the job and drop onto pre-drilled fronts. Companion pieces in the Asbury series carry the same finish and design language, so mixing knobs on doors with pulls on drawers stays consistent across the installation.
Yes. The center-to-center spacing is 5-1/16 inches (128 mm), so it mounts directly onto any front drilled to that pattern.
The squared 3/8 inch flat face aligns with the geometry of a shaker rail, so the pull reads as part of the same language rather than sitting against it.
Brushed Satin Nickel is a cool silver-tone finish that coordinates well with brushed stainless. Keep in mind that finish names vary by manufacturer, so confirming alongside your specific appliances before committing is worthwhile.
The Asbury collection includes companion knobs and pulls in the same design style and finish, making it straightforward to run pulls on drawers and knobs on doors within one cohesive hardware program.
When the hole pattern is 128 mm and the finish needs to stay neutral across a mixed-metal kitchen, this pull covers the job without asking for compromise on either count.
Sold In: 1 Each